MGnoob's latest activity
-
MMGnoob replied to the thread Remove hydraulic spool valve from Kabota L175.Thank you very much. The thread mentioned was how I realize that you can’t just block them off. I’m also not completely ignorant to...
-
MMGnoob reacted to TheOldHokie's post in the thread Remove hydraulic spool valve from Kabota L175 with
Like.
Yes, you have to loop the hoses together. The two ports on the tractof are likely BSPP. Dan -
MMGnoob posted the thread Remove hydraulic spool valve from Kabota L175 in Service, Repair & Maintenance.It is my understanding that I can’t just plug this off at the hydraulic cover. Is that correct? I want to remove it because it’s...
-
-
MMGnoob reacted to Russell King's post in the thread I have a L175 and the RPM gauge does not work. with Like.
I have not needed that part so did NOT order it.
-
MMGnoob replied to the thread L175 engine front shaft.Excellent. Thank you I’m also on the lookout for the pulley that goes on that shaft I may utilize that for the attachment point if I...
-
MMGnoob replied to the thread Gearbox repair for FMC sidewinder.Both useful suggestions. I did get it off. I will be disassembling that brush hog and addressing the gear box. Likely with a replacement...
-
-
MMGnoob replied to the thread Gearbox repair for FMC sidewinder.The current shaft on the gearbox has a 7/16 shear pin. Can I just buy this and drill out the 7/16 hole on my driveshaft to half inch...
-
-
MMGnoob replied to the thread Gearbox repair for FMC sidewinder.I like that answer. Is there any way to shim the horizontal shaft further into the vertical shaft to gain more engagement? I’ve never...
-
MI would say it's salvageable, but the gear teeth are a long way from "new condition". You can clean and dry the gears, then using a...
-
MI’m looking for Parts to rebuild what I believe to be an FMC sidewinder.. i’ll attach some photos. I wish I took better ones when I had...
-
-
MMGnoob replied to the thread ROPS installation L175 & L225.One step ahead of you on that I already did the 10 on the front mounting plate where the bumper or hydraulic pump would go….. whoever...
-
MMGnoob replied to the thread I have a L175 and the RPM gauge does not work..Did anyone order the part? Has anybody ever disassembled one to see if it can be repaired? I’m not sure if mine works. I don’t see it...
-
-
MMGnoob replied to the thread L175 engine front shaft.thank you I misinterpreted your drawing. Both options are similar to what I figured had to be done. You could probably hand make...
-
MMGnoob replied to the thread L175 engine front shaft.This is similar to what I was looking for… what I don’t understand is how the shrink disc over the sleeve you made grabs onto the...
-
MIf this setup is similar to the one used on the B5100 tractor, I was able to make a sleeve that just slides over the male splines in the...
