Recent content by Mercvrinvs

Hi guys! I mounted a F.E.L. on my tractor & a tool on the 3PTO hitch. So, I checked the level after to stoped the engine & all tools in "down" position. The level is in "high" position. It's OK! But when the engire's running it's difficult to lift at the same time front & rear tools in "high"...

Hello! There's a problem with the direction box of my tractor. There's vertical play on the shaft ! I tempted to turn the screw at the side of box but there's a sort of notch on the sector shaft... If I turn the pitman arm with hand, I can see the direction shaft up & down a little (less than...

Sorry. I just replaced fluid & filter for few days ago... It's just a big review ! It will be hard, I think... :/

Hello, Do you think it's possible to adjust the flow rate of the pump? Yesterday I disconnected hydraulic line from pump to rear 3pt hitch cylinder & the fluid leaked slowly.... Maybe the pump pressure the fluid just when the line is closed? Or maybe there's a problem with my pump? Sometimes...

Thanks a lot ! But I think this kit is designed for 2WD tractors because it seems to disconnect the transmission shaft to front axle..?? So a front 3pt hitch kit exist for grey market tractors ! It's manufactured by TDO, look : But this kit can be only used with hydraulic implements because...

Do you know a manufacturer of front PTO kit for our grey tractors? I found some kits for B or BX series (with central PTO) but not for my L02 series. Like this : http://mkmartin.ca/products/front_mount.php Do you think that sort of part exist or not?! Thanks.

Probably....?? Mmmm..... The problem is the number of plates is different on each emplacement. Right Wheel 5 on front 4 on rear Left Wheel 6 on front 5 on rear I think I have to mount the same number of plates on each side of pivots? The number can be different on each wheel but not...

Look at the part #13 on the top image. I thought it was a classic paper joint but in fact, it's a special joint composed by some metal plates. I think the metal plates are used to compensate for gear wear inside the reduction case of each front wheel. What do you think about that theory? Thanks.

I want to replace oil in my 80's L2202DT (manual steering) but I don't know how to purge steering box !? I tempted to unmount the big bolt in the center but there is a screw below.... So I think the little red & square nut is the filler plug but I don't know....? I'm not sure the big is the...

Yes, yes I confirm. ;)

I wanted to enlarge the front thread 'cause of the front wheels are smaller than at the rear. When I turn on the slope, sometimes the rear wheels are raised.... So I prefer do that in 'reverse driving' (I don't know if it's the correct expression?)... But I ever have some problems in the...

Really?! But the tie rod is exactely curved at the two same opposite side ! It looks like manufactured. Or maybe it's not the tie rod for this tractor model ? So you think it have to be straigth !? I need to find another !!! X(

Hi ! I have a DT tractor (L2202 gray market) & I can't enlarge the front axle width. I don't have rims with many possible positions... So can I reverse the rims (inside to outside) to enlarge the tread width ? Is that will cause problems to my axles ? I don't read this possibility in User's...