Recent content by Mbiggs

That is a fair question and probably the answer. Even though it’s old, I’m abit of a perfectionist, and want everything as original as possible. Odds are, I would never use it honestly. But if it’s a reasonable fix, I would probably spend the money

Well had a chance to mess with FEL. Unfortunately it appears the detent has failed. It will go into float mode but pops back out. Any cost ideas of what it would take to get working?

Awesome. I will have to check it out. Sorry for stupid question. First Kubota. First tractor with FEL so learning curve. so essentially, I push hydraulic control forward, then give it a little more?

Stupid question, have a new to me B1750 with 1640a loader. Assuming loader is too old to have a float mode for the bucket, or is it just operator error on my end, as I can not see a way to get loader to float

New here. Bought a new to me b1750. Been working through minor issues but noticed while in high gear on flat terrain, I can barely get engine to pto rpm speed. The cluster shows pto rpm’s around 2400. But that seems to be slightly higher than I can get a full throttle without any pto engagement...