Recent content by Matt1976

Fluid leaves the pump going to a distribution block then to the loader valve. Through the loader valve back to the distribution block. All the while the block communicates the system before the loader valve. With that being said, is it possible that the 3pnt relief could be dumping the pressure?

I do have a flow meter. Not quite 0-10 would be large enough though. I’m not trying to save any money by not going to a dealer. There is a 6-8 week waiting list to get in.

All the hoses are correct. Machine was operating properly. The hose blew. Hose was replaced. Has been the same since.

Thanks I will check it out and let you know the outcome.

Thanks dave but this does not appear to be the same valve bank I have.

I would assume a weak spot in the hose.

Filters and oil was changed at the same time I changed the loader valve. Not even an hour since. Only been running while trying to fix this thing. Hoses are not swapped to the best of my knowledge. 3 pnt was all in working condition. Is there a plumbing diagram available anywhere?

It blew the hose coming from the pump to the FEL control valve. Changed the hose and has not been the same since. Changed the hose again thinking it may had been restricted or faulty. Still the same. Checked all the cylinders to ensure none were bypassing internally. Lead myself to believe it...

FEL has no power. Barely will come off the ground at WOP. I did check the pressure at the rear remote port its showing 2000 psi. Can someone help me with further troubleshooting my issue?