MartinmMc's latest activity
-
M@MartinmMc - - You're fortunate to have Dan (@TheOldHokie) helping you out. Couldn't count how many times he's helped with...
-
MThe outlet block is the one up by the floor boards. If your remote valve dumps into the top of the transmssion case this may have...
-
MMartinmMc replied to the thread B8200 no hydraulics.The circled area is the a return flow into the top of the transmission case, I think you were referring to it as the tank. What is the...
-
MMartinmMc replied to the thread B8200 no hydraulics.Yes I've stood on the arms
-
MIt does not matyer. The arms came up so the pump is working. Check and confirm the position of the selector valve on the outlet block...
-
MMartinmMc replied to the thread B8200 no hydraulics.The direction valve rotates, but doesn't have stop, just rotates I've redrawn the hydraulic flow circuit
-
-
MMartinmMc replied to the thread B8200 no hydraulics.No load on the arms
-
MMartinmMc replied to the thread B8200 no hydraulics.Hi Dan, The valve under the seat is apparently used to slow down the lowering of the hydraulics, that's what I understand it's for...
-
MMartinmMc replied to the thread B8200 no hydraulics.Hi Dan I've attached a pic of the hydraulics system. The knob on the selector valve position is where it's always been prior to this...
-
-
MTry to take some pictures of the hydraulic lines on the tractor with labels as to what goes where. Then post them. Take a picture of...
-
MMartinmMc replied to the thread B8200 no hydraulics.Thanks for the advice. I took the hose off and powered up the tractor, but no flow out of the hose & checked the lever was in neutral...
-
MCheck the control for the rear remotes and make sure it's not stuck in a position other than center (neutral). Check the oil level in...
-
MYou can remove the hose that comes out of the POWER BEYOND port of the FEL. take the far end loose (it might be connected to the rear...
-
MHi Everyone, Newbie here from the UK, I'm hoping for a bit of advice regarding a loss of hydraulic pressure. I have an FEL attachment...
