lmichael's latest activity
-
LHow do you lose a Pre-Screen. You take it out and clean it and put it back in. Not as it it can fall out.
-
LReplace the pre-screen, get a radiator genie air as suggested above for routine cleaning, and use coil cleaner and the radiator genie...
-
LThey are very simple to clean; you need the correct tool. If you use one of these styles of blowguns, they are no problem blowing the...
-
LThis is the second post where you want to complain about Kubota's prices on parts. We really don't need to hear / read it. If you don't...
-
Llmichael replied to the thread G5200 (D600) drain cock valve thread pitch.So if the drain cock is NPT threads on this I'll assume same for the D728 in my G2160? And if so any possibility temp sending unit is NPT?
-
Llmichael reacted to dlundblad's post in the thread G5200 (D600) drain cock valve thread pitch with
Like.
I didn't find a thing online about this so I figured it was worth posting up in more detail. Mine ended up snapping off from the block... -
Llmichael reacted to PoTreeBoy's post in the thread 48 inch Kubota Deck that know one can identify - RC48RTG with Like.
If you can disassemble the spindle, you should be able to source bearings and seals from an auto parts store or a supply house. The...
-
Llmichael reacted to GreensvilleJay's post in the thread 48 inch Kubota Deck that know one can identify - RC48RTG with Like.
Usually any 'bearing supply company' can measure your seals and bearings and help you out, so you won't have to pay $$$$$ for a $ bearing !!
-
Llmichael replied to the thread GR2110 Alternating voltages wont start Very confused ! LOL Totally lost at this point ANyone have any ideas ?.Don't even bother doing further troubleshooting until you have the battery issue resolved. Start with the basics (the source) and work...
-
Llmichael replied to the thread Reviving a G1900.I would think the reluctance of the flywheel teeth going by should generate plenty of signal. If you think about it on FI vehicles where...
-
LI found the issues. I tested all the switches, but they all worked ok. I temporarily bridged them and continued to look around. It...
-
LIf it does not start every time you bridge the battery lug to solenoid its battery, battery cable, starter, or starter ground. Dan
-
Llmichael replied to the thread Reviving a G1900.I literally was just not paying attention when I bought it. I'm actually pretty well versed in metrics (actually prefer it to our US...
-
LMy cheap Android phone will give me the answer without the internet and its more reliable than my arithmetic :rolleyes: Dan
-
L@lmichael just remember that 1 inch is 25.4 mm (or just use 25 if you don’t want an accurate measurement) X inches * (25.4 mm/1 inch)...