kcs 61's latest activity
-
Kkcs 61 reacted to chim's post in the thread Wrenchly to log/track maintenance for everything on your phone with
Like.
Welcome aboard. That's interesting. I use Felt Tiply. New filters are marked with the date and hours. Mower deck gets greased every... -
KI have an older model L2800D tractor and the front left tire has a wobble. I can't tell if it's the tie rod or the steering arm...
-
Kkcs 61 replied to the thread Fuel Storage (small containers).I’m in the same boat as you. I keep a 5 gal filled. I use very little fuel. I treat the 5 gallons too keep condensation out if it then...
-
Kkcs 61 replied to the thread 15W40 or 5W40.Awesome thanks for all the help and quick responses.
-
Kkcs 61 replied to the thread 15W40 or 5W40.Would it be ok to run that in the summer too? I mow about 3 acres in the summer time
-
KI want to switch my B2650 to Rotella T6. I currently run Rotella t4 15W40. When I switch over should I run the 5W40. Or still run the...
-
KIt says its a B section pulley which is a 5/8" belt. Dan
-
KJust a quick question. I have a very new LX2620 with 21 hours on the clock. The main driveshaft off of the engine is producing a...
-
Kkcs 61 replied to the thread Non-Dealer Source For 2502 Oil/Trans/Hyd Filters?.I get all my filters and SUDT from my dealer. I found out it’s cheaper for me than at Amazon
-
Kkcs 61 reacted to Mustard Tiger's post in the thread Doing the 50 hr service today on BX23S... with Like.
Will be doing the 50 hour service on my BX23S later today but wanted to check in to make sure I don't need any additional parts or...
-
Kkcs 61 replied to the thread Fair Price for cutting.I charge $200/hr. With a minimum of 1 hour. And if I have to travel more than 10 miles it’s $5 per mile
-
Kkcs 61 replied to the thread Land Pride RFM (1672 Vs 2572) behind a B2650.Yup mine came with soils tires. I grease it twice a year and change the gear box oil at the beginning of each season. I have 2 sets of...
-
Kkcs 61 replied to the thread Land Pride RFM (1672 Vs 2572) behind a B2650.I run a 1660 behind my B2650. And it handles it fine. I can cut grass 8”-12” and it goes through it fine just low and slow with the...
-
Kmight try 2, thin but WIDE bladed screwdrivers. on opposite sides,twist and see if it releases the 'pins' from the 'sockets'. In your...