jyoutz's latest activity
-
Pretty much all my implements I use on my MX6000 are Cat one. I changed the pins on the ones I could and the ones I couldn't with out... -
jyoutz replied to the thread MX6000 and Cat 1 implements.I have replaced the pins on several of my Cat 1 implements with Cat 2 pins. They aren’t too expensive and are sold at TSC. Using a...
-
jyoutz reacted to GeoHorn's post in the thread 20 hours on new Machine, Hydraulic Pump Failure, Advice needed. with
Like.
Seems like a good solution to me. I bought a new Ram 2500 out of state …(my truck was wrecked in KY while on a trip) ….and the transfer... -
jyoutz reacted to Trash Panda's post in the thread 20 hours on new Machine, Hydraulic Pump Failure, Advice needed. with Like.
Obviously a completely different machine, but when the pump went on our 299D skid steer, both drive motors followed shortly after...
-
Although not exactly like the cars earlier in this thread, this Ford Model T was assembled and driven in 2 minutes and 50 seconds.
-
Financially, check the values on tractorhouse. Is it a good idea? Nah. I'd keep the excavator and get a used tractor to go along with...
-
jyoutz replied to the thread Build a car piece by piece.Didn’t Johnny Cash have a song about this?
-
We had fawn triplets in the yard this fall too, quite the sight. I think the weather and lots of food has helped their population. I see...
-
If the tractor has been rolled onto its side, it could have very easily done damage to the emissions system and that's not cheap to fix...
-
Look elsewhere. You don’t want this tractor!
-
It could just be the odd angle of the picture but, it does look like something could be tweaked. I’d request additional pictures from...
-
I've never filled tires myself but it's not a technically hard thing to do. I have Rim Guard in the rear tires of both tractors as well...
-
jyoutz reacted to lmichael's post in the thread Rear tire fill - your thoughts appreciated with Like.
Nice thing about loading the tires is the weight is not on the axle and bearings but right on the ground where it belongs.
-
jyoutz replied to the thread Rear tire fill - your thoughts appreciated.Check out bio ballast. It a lot less messy than rim guard and non corrosive. It’s also better on the tire rubber than WW fluid...
-
jyoutz replied to the thread Good Morning.It’s very much fall in northern New Mexico. Been raining off and on all week and the aspen leaves in the mountains are at peak color. We...
-
