jyoutz's latest activity
-
Not to hi-jack your excellent discussion…(this comment is for those who came to learn about sump grinders because they have a problem... -
thanks, in the 2nd picture , you can clearly see one wire is not connected to the actual 'coil' wire. A picture of the coil where the...
-
It's a nice pallet and I don't doubt that it's sturdy enough and that it works as intended. It would be an interesting exercise to...
-
jyoutz replied to the thread adapting older implements whose 3-p5 attachment points are too high?.That’s exactly what I was referring to in my previous post. It’s doubtful that reduced lifting capacity would be an issue. very few...
-
jyoutz replied to the thread Finished my fueling station.The pallet has stamped and welded panels and is more than sturdy enough for its intended use. I bought 2 pieces of 1/4” flat steel...
-
jyoutz reacted to GreensvilleJay's post in the thread i need help with these errors on my L 3560 tractor with
Like.
curious, the ECU ( for the HST version ) is $1500 CDN. Can't believe it's that cheap.... Big questions though... 1) can it be destroyed... -
Whether or not it's worth the cost will depend on what you use it for. Six scarifiers on a 55" inch box blade ... that's probably a...
-
Obviously, I don’t have a LX3310. It has side plates so flimsy they have sheet metal stiff back braces that look like they’d be more...
-
@jyoutz : That’s a nice set-up…. And that’s a Very Good Filter set-up. Don’t worry about changing that filter element…. EVER. (no...
-
I built a wooden pallet for my 100G transfer tank. It's been 11 years and it needs to be rebuilt. It sits outside all of the time...
-
jyoutz replied to the thread adapting older implements whose 3-p5 attachment points are too high?.My tractor has a couple of different holes to adjust the lift arms. Check to see if your tractor can be adjusted for higher lift.
-
jyoutz reacted to Old Machinist's post in the thread adapting older implements whose 3-p5 attachment points are too high? with Like.
Also look at which hole you have the tractor end of the top link in and shorten it some to make it lift higher.
-
jyoutz replied to the thread Cheaper than Cheap Lightweight Box Blade.It performs great behind your garden tractor, but a compact tractor would probably tear it up.
-
jyoutz replied to the thread Cheaper than Cheap Lightweight Box Blade.I don’t recommend that implement. It says cat 0 and cat 1. Anything that is light enough for cat 0 is going to be flimsy.