Jsjac's latest activity
-
Jgot rid of about 1/3 of my stockpiled horse poop today
-
JJsjac replied to the thread Logging arch.Looks more like a cable plow or tubing plow than a logging arch. Maybe?
-
JJsjac replied to the thread What did you do to or on your Kubota today?.We got a little snow yesterday. Used the snowblower to clear the driveway and around the wood sheds. Would like to cut wood tomorrow but...
-
JJsjac replied to the thread Help Me Pick Out A Model... 3.5 acres 400' driveway.If you are going to use it for snow removal I would recommend something with a cab. Unless you can picture yourself sitting snow covered...
-
JJsjac replied to the thread L3130 stalls.Couple questions? Does it just die like turned the key switch off or does it die down? Are you sitting back in the seat? Maybe the seat...
-
JJsjac replied to the thread Dumper trailer choice.Here is a kit with everything for one axle. The only thing it does not have is the backing plate mounts. Not sure if the spindle size...
-
JJsjac replied to the thread At what temperature do you plug in your block heater?.I only plug my tractor in when it is below zero
-
JJsjac replied to the thread What can cause air in home plumbing?.Any updates on your air in the water system
-
JJsjac replied to the thread Went grapple shopping at the local dealer.I have stopped by a few tractor dealers looking at grapples and skidding winches. I would say there are two kinds of dealers. Ones...
-
JJsjac replied to the thread What can cause air in home plumbing?.Where the line goes down the well it is connected to a fitting on the side of the well casing. It is called a pitless adapter. There is...
-
JJsjac reacted to WI_Hedgehog's post in the thread What did you do to or on your Kubota today? with
Like.
If I earn it I burn it. If I do the work I buy the tools. Problem is excavators are expensive and I can't yet justify the cost, but... -
JJsjac replied to the thread Looking for a reliable Z121 starter motor.Why would you not buy a factory Kohler starter. Most of the after market starters bo not last very good.
-
JJsjac replied to the thread Lx2610 glow plug relay.I had the same problem with my B2650. The connector that is on the load side of the relay were loose. I tightened them up and it has...
-
JJsjac replied to the thread Boyd Inspection Plate Installation.why would you not remove the tank to clean it out?
-
JJsjac reacted to ArcticOrange's post in the thread Help Identifying Metal in D1105 oil pan with Like.
I reassembled it and ran it for 2 hours with no I'll effects. I will post back if it blows up.