jaxs's latest activity
-
Jjaxs replied to the thread "Burnishing" your new brakes. WTF......... Now I've heard it all. (I'm raising the Bullsh!t flag)."Burnish" is a poor definition for it. Burnish actually describes a condition I would call "glazed" which results from overheating...
-
Jjaxs replied to the thread L3350 Battery Replacement Options.Measure you case and take note of + - post arrangement and buy the largest group size possible. My trailer, 841 Ford, 65 MF, 97...
-
Jjaxs replied to the thread Punctured rear tire, L-35, thoughts/advice?.I 3 to 1 prefer patch from inside over plugging. Why can't you take the tire in for repair? If hoe is on it that takes car of jack...
-
Jjaxs replied to the thread B2920 no crank issue experience solved.Welcome to OTT 507, it was very thoughtful of you to share your experience.
-
Jjaxs replied to the thread Kubota M5700 AC Control Blowing Fuses.You will really be miffed if it turns out those $97 switches were shorting internally causing the problem all along.
-
JThis little batch of Southwest heat that blew across Northeastern states ?
-
Jjaxs replied to the thread Kubota M5700 AC Control Blowing Fuses.Since switch was the problem in 23,do same tests as you did in 23 but in reverse order this time. As for paying $97 for a switch, I'd...
-
Jjaxs replied to the thread Possible project.Parts are easy to find and reasonably priced. If select-o-speed needs work not many people work on them.
-
Jjaxs replied to the thread B2400 overheating.What Wolf said and I might add that a cracked head/blown gasket can lead to more serious damage if it's continued in use. Before you...
-
Jjaxs replied to the thread B2400 - overheats when mowing after ~20 minutes.I noticed you said "white line" instead of a temperature. That's a common gauge but installing a quality sender and gauge marked with...
-
Jjaxs replied to the thread Fuel blockage in tank.There's often a strainer/sieve to catch large debris. I would expect it to glogg again shortly unless debris is removed from tank.
-
Jjaxs replied to the thread A little Machinist advice please.I could be mistaken but if shaft,bore and key fit snug you might be able to salvage and reuse the whole assembly without need for parts...