JasonW's latest activity
-
JJasonW replied to the thread Transmission Oil Sight Glass.No not completely. Just drain just below the sight glass. Or if you’re comfortable have a drain pan ready and remove the old sight glass...
-
JCorrect no crank just a click when I turn key.
-
JJasonW replied to the thread B3300 won't start when hot?.More details will help like Wolfman suggested. My suggestion assumes that when hot it’s a no crank situation.
-
JJasonW replied to the thread B3300 won't start when hot?.Add to the above go through and check all your connections to the starter and battery first.
-
JJasonW replied to the thread B3300 won't start when hot?.I would say it’s the starter or the starter relay. Works when cold but doesn’t when hot/heat soaked. Try to find a place local to you...
-
JJasonW replied to the thread "New" Mower. Tell me How I Got Cheated.I’ll add to the starting situation. You have the parking brake switch, left and right control lever switch and the seat switch.
-
JJasonW replied to the thread First Time Buyer MX4700.Is the model you’re looking at in Bardstown KY? If it is it’s listed on tractor house for $22K. Two others listed are 4wd for $28.5k...
-
JJasonW replied to the thread "New" Mower. Tell me How I Got Cheated.Only you can decide if you need the scalp wheels or not. My yard is what I would call flat and my wheels hit quite a bit. My ZD331 has a...
-
JJasonW replied to the thread L3400 transmission dipstick.Just looked on Messicks. It’s listed under options, so it’s not standard. Showing $23.
-
JJasonW replied to the thread First Time Buyer MX4700.Just guessing because the 2wd models are gear drive only, some responses say you need an HST for loader work, or that it’s easier...
-
JJasonW replied to the thread First Time Buyer MX4700.The only difference in the steering is that with a full hydraulic setup the steering wheel might not end up on the same position all...
-
JJasonW replied to the thread 3 Pt. Rotary cutter with a hydraulic rear end.What width are you looking for? I believe they are called semi mount, any that design would cost more than a standard 3pt one. Most...
-
JJasonW replied to the thread L2501 Overheats under load.I would say it’s probably fine. But it’s almost ten years old and the manual states to change coolant every two years. So couldn’t hurt...
-
JJasonW replied to the thread L2501 Overheats under load.As said above make sure there isn’t debris in the radiator fins. Also check the fan belt tension, it can’t cool off if it can’t move air...
-
JJasonW replied to the thread Low RPM on PTO.Every time I’ve ran a PTO spreader I’ve ran it lower than 540. You didn’t mention if your tractor is a gear drive or HST. Gear drive...
