JasonW's latest activity
-
JJasonW replied to the thread "New" Mower. Tell me How I Got Cheated.I’ll add to the starting situation. You have the parking brake switch, left and right control lever switch and the seat switch.
-
JJasonW replied to the thread First Time Buyer MX4700.Is the model you’re looking at in Bardstown KY? If it is it’s listed on tractor house for $22K. Two others listed are 4wd for $28.5k...
-
JJasonW replied to the thread "New" Mower. Tell me How I Got Cheated.Only you can decide if you need the scalp wheels or not. My yard is what I would call flat and my wheels hit quite a bit. My ZD331 has a...
-
JJasonW replied to the thread L3400 transmission dipstick.Just looked on Messicks. It’s listed under options, so it’s not standard. Showing $23.
-
JJasonW replied to the thread First Time Buyer MX4700.Just guessing because the 2wd models are gear drive only, some responses say you need an HST for loader work, or that it’s easier...
-
JJasonW replied to the thread First Time Buyer MX4700.The only difference in the steering is that with a full hydraulic setup the steering wheel might not end up on the same position all...
-
JJasonW replied to the thread 3 Pt. Rotary cutter with a hydraulic rear end.What width are you looking for? I believe they are called semi mount, any that design would cost more than a standard 3pt one. Most...
-
JJasonW replied to the thread L2501 Overheats under load.I would say it’s probably fine. But it’s almost ten years old and the manual states to change coolant every two years. So couldn’t hurt...
-
JJasonW replied to the thread L2501 Overheats under load.As said above make sure there isn’t debris in the radiator fins. Also check the fan belt tension, it can’t cool off if it can’t move air...
-
JJasonW replied to the thread Low RPM on PTO.Every time I’ve ran a PTO spreader I’ve ran it lower than 540. You didn’t mention if your tractor is a gear drive or HST. Gear drive...
-
JJasonW replied to the thread LP RCR1860 cutter lost Power.Thanks for the follow up. Always keep a few spares with you.
-
JJasonW replied to the thread M5400 won't start, have changed most everything.Yes
-
JJasonW replied to the thread M5400 won't start, have changed most everything.Not 100 percent sure but on that model the neutral safety switch should be in the F-N-R lever. Not internal to the transmission. I’d...
-
JJasonW replied to the thread Dealer runaround?.Didn’t that model have a bulletin about fuel pump issues? Sounds like they are correcting it before you pick it up. One week delay? Are...
-
JJasonW replied to the thread Radiator Recovery Tank leaks.I repaired a small hole in a plastic gas tank on a ZG127 with two part epoxy made for plastic. Not sure which brand it was though. The...