imarobot's latest activity
-
Iimarobot replied to the thread Dropping an implement with engine off.She is great and also helps me with a lot of this stuff, she's not afraid of dirt or grease (but not in our BLT's)! 😊
-
Iimarobot replied to the thread Recommended thread sealer for hydraulic application.This thread goes back a ways, but well, here I am years later. Several have mentioned different types of sealants and there are several...
-
Iimarobot replied to the thread Dropping an implement with engine off.I do both of them things and have my wife periodically check in on me in case something happened and I'm unable to use my phone.
-
Iimarobot reacted to WI_Hedgehog's post in the thread Dropping an implement with engine off with
Like.
One of the reasons jack stands are used when working on vehicles is because a hydraulic jack can fail and crush someone; it's similar... -
Iimarobot reacted to GrumpyFarmer's post in the thread Dropping an implement with engine off with Like.
I’m not sure this needs said or not…I am not the safety police, but I don’t want any of us or our loved ones hurt(so I think no harm to...
-
Iimarobot reacted to GrumpyFarmer's post in the thread What did you do to or on your Kubota today? with Haha.
Couple things: 0. I hope I didn’t upset you. 1. I don’t think ‘politician’ and ‘job’ really go together. 2. I am not sure your...
-
Iimarobot reacted to D2Cat's post in the thread What did you do to or on your Kubota today? with Haha.
GrumpyFarmer, with your ability to embellish the situation are you a politician in you everyday job?
-
Iimarobot replied to the thread Dropping an implement with engine off.Hope I remember to try this
-
Iimarobot replied to the thread FDR2584 Finish Mower HP requirement.I wonder if they spec it only by HP with no consideration for weight. Kind of like when I was specing out a flail mower. HP wise I was...
-
II seriously doubt 15HP will power that mower in anything but short lawn length grass. I had a 72" rear discharge on a B7200DT and that...
-
IMy L4240HSTC shows 35HP on the PTO. I do run a 90" that is 100# lighter than the LandPride you mention. This match-up works well. I...
-
Iimarobot replied to the thread Daily Chuckle.Or as an engineer, what did I do wrong this time???
-
II was an electronics tech for years, both in the Navy and civilian jobs. That smell was a "good news, bad news" thing: Bad news: It's...
-
Iimarobot replied to the thread FDR2584 Finish Mower HP requirement.Good point about the weight, something else I have to consider.
-
Iimarobot replied to the thread FDR2584 Finish Mower HP requirement.I would probably cut to 3-4" but wouldn't be getting up there to do it every week. That's my concern about the required HP. Your tractor...