imarobot's latest activity
-
II have a underground pvc water line that has sprung a leak somewhere. The line runs from my house to chicken coop is about 150' in...
-
Iimarobot replied to the thread M7060 - 3-Point Hitch control lever at the rear of tractor..I had fabricated a rod that attached to the linkage that the cab lever cable attaches to on top of the transmission. Has a handle on the...
-
IGeoHorn's post was absolutely topnotch. Having spent over thirty years in the commercial nuclear power industry and adding Biobor JF to...
-
IMy experience with Biobor JF began in 1980 when I became chief pilot of a corporation that owned jet-powered aircraft. As chief pilot I...
-
IRead in another post about Biobor JF which is good for removing microbial contamination and improved lubricity. Looked into this stuff...
-
Iimarobot replied to the thread Adding voltage gauge - questions.I've wired in meters to only be on when the key is on and also added a momentary switch to power always on. This way I can check battery...
-
Iimarobot replied to the thread Blue Diamond Flail Mower.PTO HP and 3-point hitch lift limits are points to consider but you also have to factor in the mower extension when it is off the...
-
IDo not own and never have used a grader scraper. One of the shop mechanics at the dealer uses one to routinely maintain his driveway...
-
Iimarobot replied to the thread Box or Grading Scraper?.I also do this for snow removal if my driveway isn't frozen and can't use the snowblower.
-
Iimarobot replied to the thread Box or Grading Scraper?.I've done that but the blade tends to just ride over the dirt unless it is soft.
-
IOne simple thing to try if your rear blade supports it, is to simply rotate the rear blade 180 degrees, so the cutting edge becomes a...
-
IMy driveway is overdue for some TLC and I’m thinking of getting a box scraper or grading scraper, and not sure which would be better for...
-
Iimarobot replied to the thread HST filter blowing out.Did you check that the filter o-ring came off with the old filter?
-
Iimarobot replied to the thread safety on a hill going straight up and down.My rule of thumb on hills - If my mouth is wide open and my a-hole is slammed tight, I'm in a place I shouldn't be.
