Recent content by Ikymojoe

  1. I

    Bush Hog or Landpride?

    I had to resort to rebuilding the spindles. I have the bearing, retaining rings, and seals. However, I noticed the bearing are not "tight" against the spindles (freely slip up and down the spindle shaft) but are "tight" in the spindle housing. Is this normal or should the spindles be "tight"...
  2. I

    Bush Hog or Landpride?

    If anyone has a similar finish mower, and your need parts, this model it is a Bush Hog ATH 600 (Air Tunnel Model) manufactured for Kubota. That is, what the Kubota service folks are telling me... I will confirm this weekend when I try to rebuild the spindles...
  3. I

    Bush Hog or Landpride?

    Motion, How would I test the spindles to see if they are shot? I know the bearings are bad. I have changed the gear box oil, blades are fairly new. I plan to sharp them. Again, mainly looking to see who might have manufactured it for future parts reference. Thanks, Ikymojoe.
  4. I

    Bush Hog or Landpride?

    I have inherited a Kubota Rear Finish Mower (RFM-60). I need to order two spindle assemblies. One dealer is telling me it is a Bush Hog ATH 60 and the other is telling me it is a Landpride AT2560? Spindle assemblies have three attachment holes. Would anyone know the origin of this rear finish...
See more
Top Bottom