Hugo Habicht's latest activity
-
HHugo Habicht reacted to Deeds86's post in the thread New member, and new owner of a L2502HST with
Love.
Awesome, thank you both for the quick replies! I dont even know what max rpm is on this at the moment, I think I read 2200 is max but... -
HHugo Habicht reacted to Runs With Scissors's post in the thread New member, and new owner of a L2502HST with Like.
Welcome and congratulations sir. Personally, for “break in” I just used it “normally”…..I know that is a bit vague, because some...
-
HHugo Habicht reacted to mdhughes's post in the thread What did you do to or on your Kubota today? with Like.
Yesterday I wanted to move some logs, so I was taking the bucket off to put the grapple on. Something didn't look right: Went to the...
-
HA bit more progress over the last few days. Still not finished, but enough to give it a test. I tried it on a piece of 6 mm mild steel...
-
HHugo Habicht replied to the thread DIY press brake.This is phantastic ! To be honest, for bending the round shape of the front bucket I do not think I would want it faster. What is...
-
HHitting the silk while tilling:
-
HHugo Habicht reacted to Blue2Orange's post in the thread What did you do to or on your Kubota today? with Like.
Better to be ahead of schedule than late. Back in IIRC '91 we had a Halloween Lake Effect early dump. ~3 feet at Lake level. Up where...
-
HHugo Habicht reacted to Blue2Orange's post in the thread What did you do to or on your Kubota today? with Like.
Just used the grapple to stack some firewood logs. Getting cold. Today's high was just a few degrees below normal, but the windchill...
-
HA serious response would be that the local Kubota dealer puts a gear oil in the front axle because it's less likely to leak past the...
-
HHugo Habicht reacted to Shawn T. W's post in the thread Need chains for R4 industrial tires on a BX23S... with Like.
I normally only run 10 psi in the back, and 20 in the front which I've upgraded to 8 ply ... Needs to be reduced to show a bulge in the...
-
HHugo Habicht reacted to Shawn T. W's post in the thread Need chains for R4 industrial tires on a BX23S... with Like.
One trick to "tight" chains is to deflate the tires, install chains, air back up ... Tight!
-
HHugo Habicht reacted to WI_Hedgehog's post in the thread Need chains for R4 industrial tires on a BX23S... with Like.
I keep the chains pulled to the outside and use three small rubber tensioners per side to keep them there. Supposedly front chains...
-
HREAL potato chips are potatoes, lard and salt here in Lancaster county where "if you ain't Dutch, you ain't much" :) I do enjoy the...
-
HI also use SUDT2 but only the stuff I drain out from a fluid change. That stuff is too expensive to use new for french fries! Forgot to...
-
HHugo Habicht reacted to NCL4701's post in the thread What did you do to or on your Kubota today? with Like.
Took the loader off, removed coolant, ran a flush, and refilled. First time using a vacuum filler. Not a tool I anticipate using...