Recent content by Hfrs7

For sale, bagger parts from a ZD 221. These are new never used. Had an insurance claim and they replaced the entire bagger. I used the parts needed and had these left over. $800 or best offer.

Here is the latest as of Friday Dec. 13. Kubota sent me their printout of my payments. The payments made equal the months on the loan. I have no clue where to go from here. I will just keep making monthly payments until the loan matures and hopefully it will work out. If not I will argue my...

Anyone having trouble with payments to Kubota Credit the last few months. I’m getting calls and letters saying they haven’t got my monthly payments since September. I have the payment history printout from KCC and from my bank. I’ve shown where none have been missed and still they tell me I’m...

I have a friend looking for an older loader to replace his bent one....see photos. Any ideas are appreciated.

I have a CID Attachments heavy duty grapple for sale. I bought it to use on my L6060. Its just too big. I had to replace my loader arms after I bent them trying to carry a large log. Its realy built for a skid steer. I bought it new and have over $2500 invested. Will sell for $1800. Its 72 wide...

Built this out of aluminum diamond plate and tube steel. Works great.

I welded this receiver in my box blade. It uses a 2” drawbar that is held in place by a pin just like a receiver on a vehicle. Sorry this picture is prior to it being painted.....

Got it....thanks. The belt was on the wrong side of the pulley. Working now. Next question..... Dealer gave me UDT for the hydro drive. Book says 20w 50 motor oil......Which is correct? Old oil smells like it contains both. UGH !!!!!!

That's right. Got a message advising me it was a tension rod. Problem now is that it has no tension. I'm trying to find a belt routing diagram to see if the belt was installed wrong by the previous owner..... thanks.

The other end of rod....

Thanks but it is not the hydro release rod. I understand the other end of the rod hooks in a notch on the axle. It keeps tension on the blade drive belt. Undoubtedly the belt is installed wrong not allowing tension to be held causing it to just fall loose. It is a diesel model with a 48 inch deck.

Just purchased a used TG1860 with a 48 inch deck. I noticed a gold colored rod hanging under it near the rear of the deck. It connects to a belt tensioner pulley but I don't know where the other end connects. I will share a photo. Any ideas??? Thanks

Thank you....

Welded these on with no extra brace required. They will hold more than the tractor will lift......

I custom made this for my 6060. It even tilts so the hood can open.