Recent content by Greg Maine

last week I revisited your hub idea. it would be perfect way to go. To do correctly I would have to remove the radiator and some other brackets to be able to remove the front pully. I am afraid that years of corrosion I would have a possibility of broken bolts and knowing how hard it is to...

back up plan

I worried about that also my plan is to have all the mass close to the crank and have a small shaft to reach the pump.

What do you think? 25mm to 25mm split coupler so i have to make a short adapter shaft 25mm to 1" coupler. I tried the split coupler I think it will tighten on the spline shaft.

Thank you. I will look into finding parts to make one.

do you have any sugestions

Thank you for all your information on my project. I have another request do you know a part number for the spline coupler that slips over the front crank spline

Any infomation on a Kubota k116 loader? I am going to try to fit it to my l245dt I have some mounting brackets. Any manual or photos would be great thank you

Thank you. I do love a challenge and I have lots of patience.

Thank you this is perfect

thank you this is what I was looking for

I have a L245DT, and I want to mount a loader on it. How are they mounted on the tractor? I have seen photos, but they rarely show mounting brackets. If I find a loader, I will need to insure I have the correct mounting brackets. Thank You