GreensvilleJay's latest activity
-
GGreensvilleJay replied to the thread BX2816 Snowblower Bare metal in the impeller housing.thanks, hard to tell(old eyes....) A LOT of paint on it !!
-
GGreensvilleJay replied to the thread How This Simple Tractor Conquered the South Pole.I still prefer the Allis-Chalmers 'Snap-Coupler' system on my D-14s. Hands down far better.
-
GGreensvilleJay replied to the thread Easier way to take off/ put on ballast box.Kinda sounds like you're putting the top link on first and THEN the lower arms ? I've always done... right lower arm,PTO shaft( if...
-
GGreensvilleJay replied to the thread BX ROPS question.It's probably a 'legal/safety ' issue so can't sell just the top section.My BX23s wouldn't fit into the 7' 'normal' door height with the...
-
GGreensvilleJay replied to the thread BX2816 Snowblower Bare metal in the impeller housing.speaking of grease... is that a Zerk on top of the worm/gear box that's never been greased ?
-
GGreensvilleJay replied to the thread Rear axle broke right inside cover.well you're one out of 1,000 that understands why FP isn't as good as the other 999 that think it is !
-
GGreensvilleJay replied to the thread Rear axle broke right inside cover.Dan sounds like you've never actually looked at how FP numbers are crunched inside any digital computers. There are lots of books you...
-
GGreensvilleJay replied to the thread Rear axle broke right inside cover.I don't think , I know the 'math' is. Have 5+decades cutting code in Assembler + 9 or 10 other languages. The root problem is that all...
-
GGreensvilleJay replied to the thread Rear axle broke right inside cover.I don't care how 'good' the FEA code is,it's still being run on digital computers with inherent,known flaws. The BEST ,most acurate...
-
GGreensvilleJay replied to the thread Chute Rotation on a BX2816 50" snowblower.query. do have the 3rd function option installed ??
-
GGreensvilleJay replied to the thread Rear axle broke right inside cover.Well I'm not a mechanical engineer but I'll assume 'they' are saying there's not enough 'meat' left in the axle after machining the hole...
-
GGreensvilleJay replied to the thread Wiring Diagram Wire Descriptions.yeah, area not diameter..silly Canada is 'kinda Metric', just like my BX23S ! Wonder if they squish the wires 'square' to make the...
-
GGreensvilleJay replied to the thread Wiring Diagram Wire Descriptions.OK, the those numbers are the for the wire diameter in mm. Don't feel to bad about it not being in the manual.. I went through the...
-
GGreensvilleJay replied to the thread Repair Plastic Fuel Tank on M7060.I have seen 'staples' that you heat melt into plastic to 'stitch' piece securely. I'd do that first the 'weld' new material over the...
-
GI'm never really sure which one I'm up without a paddle.
