GreensvilleJay's latest activity
-
GGreensvilleJay replied to the thread Wiring Diagram Wire Descriptions.OK, the those numbers are the for the wire diameter in mm. Don't feel to bad about it not being in the manual.. I went through the...
-
GGreensvilleJay replied to the thread Repair Plastic Fuel Tank on M7060.I have seen 'staples' that you heat melt into plastic to 'stitch' piece securely. I'd do that first the 'weld' new material over the...
-
GI'm never really sure which one I'm up without a paddle.
-
GGreensvilleJay replied to the thread Leveling out a field.I think running the BOG harrow. with dragging chains would be the best. Not too aggressive cutting angle and run N-S then E-W, repeat...
-
GGreensvilleJay replied to the thread BX22 Temp Gauge.this is for the BX22D, gauges look 'old skool' to me, remove the wires, undo 2 nuts, retainer comes off, meter pulls out ?
-
-
GGreensvilleJay replied to the thread Snow blower question.I made a gas powered, SSQA 48" snowblower 5 years ago, used ONCE. Then disassembled as not enough snow since. I do have a Craftsman...
-
GGreensvilleJay replied to the thread Snow blower question.1) snowblower 'should' have shoes or skids on it, same as walkbehind. 2) PTO shaft 'may' have to be cut to size. Test FULL range(up and...
-
GGreensvilleJay replied to the thread Stability question.County guys near me, when they USED to mow the roadsides, had smaller wheels on the right side, which helped 'level' the tractors for...
-
GGreensvilleJay replied to the thread struggling.Since that tractor has very few hours, yet 20 years old, I'd drain ALL the diesel fuel out of the tank, clean the tank very well, then...
-
GGreensvilleJay replied to the thread sway pin sheared off.my guess is 7/16 x 2-3/4 .
-
GGreensvilleJay replied to the thread How Big is Yours?.13/32 works.
-
GGreensvilleJay replied to the thread BX23s rear differential replacement..yes it IS a 'BIG' job..... but go slow and take lots of pictures ! Patience is the key.also dedicating a large CLEAN work table helps. I...
-
GGreensvilleJay replied to the thread B2601 Alternator.1st off , the 'local Kubota service guy' sounds like he's NOT an electrical expert. Can't do simple, baseline troubleshooting of...
-
GGreensvilleJay replied to the thread L4310, HST, 4x4: hazards/turn signal.FYI.. Kubota generally uses BLACK as their GROUND wire colour code, so if those rear lights have 3 wires and one is BLACK, it probably...
-
GGreensvilleJay replied to the thread 150ft drive and stump clearing BX23S.In my neck of the woods, have to pay for an 'archealogical survey' before you can build 1 house or a subdivision. They found couple of...
