GreensvilleJay's latest activity
-
GGreensvilleJay replied to the thread OEM Ignition Switch for ZD326 Worth the Extra $70+?.1st issue the 'battery cables' . Both of those need to be replaced with nice,new molded ended ones. A LOT of 'electrical issues'...
-
GGreensvilleJay replied to the thread Box Trailer BX23S.Odds are good your F-150( > 1996) is already prewired for a brake controller. Look under the dash wher ethe OBD-II connector is, should...
-
GGreensvilleJay replied to the thread Hour meter/tach problem.no Hall sensor, just 1/2wave DC signal from alternator. All the 'signal conditioning' is done in the 'dash computer'. 'They' obviously...
-
GGreensvilleJay replied to the thread Hour meter/tach problem.'close but no cigar' Tach is usually 'RPM' a number of Revolutions per Minute, wheras 'Frequency' is the number of transitions or...
-
GGreensvilleJay replied to the thread Tachometer 'Flutter'.curious so checked, yes cable driven, so odds are cable is 'damaged', maybe from being kinked or bent too sharp. best to remove from...
-
GGreensvilleJay replied to the thread BX2380 Mower Deck Help.don't have one but think mower number -bx23 or similar should be on the tag ? since you're in the USA, try to 'build a BX' and look at...
-
GGreensvilleJay replied to the thread Offsetting rear blade ... should I grease it?.I use red spraybombs of 'Rustcheck' for things that need sliding, like pallet forks and PTO shafts. It's not 'thick' like grrrrease but...
-
GGreensvilleJay replied to the thread Hour meter/tach problem.yes, sure sounds like the alternator is NOT sending the pulses to the cluster. If you have a DMM with 'tach' option, probe the 'tach'...
-
GGreensvilleJay replied to the thread "New" Mower. Tell me How I Got Cheated.re: There is no schematic for the controller. That is annoying. It would be nice to know exactly what's happening in there. It would...
-
GGreensvilleJay replied to the thread Land Pride SGC0554 Claw Grapple Grinding Noise??.1st thing I saw was that some lazy SOB needs to snag HIS palm on one of those cotter pins and NOT have a box of bandaids real handy ...
-
GGreensvilleJay replied to the thread OEM Ignition Switch for ZD326 Worth the Extra $70+?.I've got 2 or 3 'tubes' of them here, industrial temp range.... still made, though cheaper to buy a PIC microcontroller !
-
GGreensvilleJay replied to the thread OEM Ignition Switch for ZD326 Worth the Extra $70+?.this .... ORL orange/black should probably be ORB orang/black , to be consistent with B being black....
-
GGreensvilleJay replied to the thread OEM Ignition Switch for ZD326 Worth the Extra $70+?.simply install a form B (normally closed) fuel valve in the fuel line. No power to it, NO fuel to Injpump, engine stops running.
-
GGreensvilleJay replied to the thread Box Trailer BX23S.YES, rear jacks are a must ! Also backup lights. SIMPLE with 7 wire hookups.2 per side(high and low)
-
GGreensvilleJay replied to the thread Box Trailer BX23S.You'll need one with two 3500# axles, best of brakes on BOTH axles. By 'box' do you mean enclosed' ?