Recent content by gleneben

I don’t think any hoses are crossed up , when I took the valve apart there is a Square piece of metal with a 1/8” hole in the middle of it at the bottom of port D Is that supposed to be there or is this a replacement for a different model. I know my dad was at least the fourth owner from the...

i will post pics soon as i can , thanks for the info.

is that common for most after market valve bodies ?

i have been having issues with bucket tilt , i found out that both tilt cylinder rods are bent. replaced both cylinders and when you pull or push the lever the line to the will pressurize but the bucket wont move. i swapped the lines from the lift cylinders and the bucket works fine and the lift...

i know ! i was a mechanic in the army for 20 years and never experienced anything like this. if you have pressure , you always have pressure. and when you don't have pressure you never have pressure, i doesnt come and go.. i have to put it all back together and set some fence post with auger, i...

yes they both are on the right side but when the fluid came out of the valve i blew air through the hoses and the lines in both directions. i got nothing but air, no debris. i even ran a #6 copper wire (rounded the end on a wire wheel so not to gouge the hose) through it to make sure i it was...

with no lines on the right side of the control block the best i could get was about a 3" high stream. when i took one of the lines off the left side , well that wasn't a good idea i'm not sure how high it went i let go of the lever and tried to get out of the way. left side has REALLY good flow...

i will try that first

im going to try that after i check the control valve for debris

i will check for that , i used the liquid teflon but when i took teh lines off they were installed with tape.

it was my fathers and it did work, i rebuilt the tilt cylinder on the left side but i did not start having issues till i changed the hoses.

i took both lines on the right control off and got a spit --- drip ,drip ,drip basically nothing

i will do that tomorrow and let you know what happens