Recent content by gary8588

Thanks, yes I figured it would serve a purpose like that. The link bar is fairly loose. I can move it by hand into position where the pin should then lock it into position. The screw here doesn't look original and doesn't hold the bar properly. Its also loose. On first look yes, it...

Can't really put a straight edge on the pulleys since they are uneven and the tension pulley is in the way. Did the same on the underside on the pulley holders without the blades on and yes looks slightly bent. Your BX1880 seems to be a fairly new tractor so yours should be straight still...

It looks like it fits! The only difference is that 76539-34554 has a right-hand thread on the top instead of a left-hand thread. It doesn't really matter in my opinion you can just use a self-locking nut. Here a comparison between the incorrect blade shaft and the correct blade shaft: no...

thanks again, will report back if 76539-34554 fits

Unfortunately I can't open this page. I am getting a "Access Denied". I believe american companies are blocking access from europe for regulatory reasons...

I'd do this as a last resort kind of thing. Since I got the pulley holder already I only need the blade shaft. The Deck Spindle you linked is from a RCK60. Thats a newer model and is built differently. @Bee-Positive thanks for the part list, I went to do some research and found another part...

Thank you very much, yes I figured that there wouldn't be many people that could measure it for me. Anyway I unfortunately can't seem to find part number H7650-34550 in my country (austria). I still can get the one I highlighted "76539-99720" at some online shop. Even though it is discontinued...

Hello! I have a middle mount mower which I believe is a RC60-B mounted on a Kubota B1750. Unfortunately the serial number can't be read anymore. I am currently rebuilding it, switching out bearings and so on. Unfortunately the previous owner might have installed a incorrect blade shaft on the...