Fedup's latest activity
-
FFedup replied to the thread L4760 PTO won't disengage when shut off.Yes, it should move about 1/4 turn until the brake plate hits the main case and stops the shaft from going any further. I guess at this...
-
FFedup replied to the thread Output gasket for Omni gearbox on landpride rcr1248.If there's any gap at all when you dry fit the cover, I wouldn't use the silicon method. You don't want to rely on silicon to fill a...
-
FFedup replied to the thread L4760 PTO won't disengage when shut off.With engine off can you turn the PTO shaft more than just a few degrees in both directions before it stops? If yes, then the plates are...
-
FFedup replied to the thread Output gasket for Omni gearbox on landpride rcr1248.Checking contact pattern would be just a "peace of mind" thing, as no shims or adjustments appear to be involved. Straight cut gears...
-
FFedup replied to the thread Output gasket for Omni gearbox on landpride rcr1248.As I see it the gasket has no bearing on gear contact adjustment. The bottom bearings and spacer sleeve fit into a machined bore in the...
-
FFedup replied to the thread Removing Cab from a Grand L 40.Maybe I'm just stupid, but I have to wonder WHY you need to do that? Having split literally hundreds of cab tractors (both large and...
-
FFedup replied to the thread OEM service tools source?.You might try this. Fit wrenches on both tie rods and try to break one loose from the steering cylinder rod. Maybe the one you're after...
-
FFedup replied to the thread Rotary Cutter output shaft dropped away from PTO gear..You won't know if it's repairable until you see all the parts. If the bottom gear has moved downwards and no longer contacts the top...
-
FFedup replied to the thread M4700 power issue??.If you have the repair manual, read up on the procedure for clutch pedal free play adjustment. That would be good starting point...
-
FFedup replied to the thread M4700 power issue??.I'm not sure why, (maybe it's just how you phrased it) but that sounds more like a clutch slipping issue than a low power problem.
-
FFedup replied to the thread White 2-105 pto speed?.It seems to me the tractor should have two sets of gears in the PTO housing. You remove a snap ring on the back, pull out one shaft and...
-
FFedup replied to the thread M7040 shuttle problem.My take is simply this. There are obviously hundreds of these tractors out there using this system. Since it's not electronic (like so...
-
FFedup replied to the thread Is the bearing underneath the front axle seal good or bad? Am I paranoid?.How did you clean the bearing(s)? If you washed them totally free of oil and dried them, they WILL make noise when spun. Add a few drops...
-
FFedup replied to the thread First Post, Fuel Issue L3901.So if it's just not getting fuel out of the tank, why not go out with CLEAN jug of CLEAN fuel nd short length of fuel hose. Remove the...
-
FFedup replied to the thread Hydraulic performance fade..Maybe not, but if you plug a gauge into a coupler and deadhead it as you suggested earlier what does that tell you that this doesn't...