ejb11235's latest activity
-
The lawn originally sloped downhill away from the driveway, dug that out with the BX to make it relatively level (minding drainage... -
ejb11235 reacted to GreensvilleJay's post in the thread BX Bucket edge, Piranha tooth,pro or straight? Pros and Cons of each. with
Like.
you can back drag ,in 'float' position, all day long -
ejb11235 reacted to Runs With Scissors's post in the thread BX Bucket edge, Piranha tooth,pro or straight? Pros and Cons of each. with Like.
Joe, I can't comment on the Piranha bar, but if I recall correctly, most people advise against "back blading" with the front lip of the...
-
ejb11235 replied to the thread What did you do to or on your Kubota today?.I picked up a Rankin 22-60 rear blade. I had made my peace that I wasn't going to find a blade that had the offset and tilt, but when I...
-
-
No, it will not restrict air flow. It is a Kubota offered option. An inner air filter can be added to any BX series tractor except the...
-
Any number of ways you might pull/skid logs with your tractor. But first and foremost....consider the 'safety' factor. Just how big...
-
My L48TLB is 19 years old, and I do not believe that any hose has ever been replaced. They all seem reasonably soft/supple. I suppose if...
-
I've had my BX2380 since 2017. I have no intention of replacing radiator hoses or fuel lines unless they break, which I doubt will...
-
ejb11235 reacted to NCL4701's post in the thread What did you do to or on your Kubota today? with Like.
Cleared some deadfall off the trails a couple days ago. Grapple and winch both made it much quicker and safer than chainsaw and muscle...
-
ejb11235 replied to the thread BX2680 - 400 hr service questions.Did you watch Messick's videos about the safety filters? https://www.messicks.com/school/secondary-or-safety-air-filters-on-kubota-eng...
-
T DCV leakage oil exits the cylinder via the ports at either end of the cylinder. The piston seal, which is in the middle of the...
-
Drop is normal. Next time, put jack stands underneath for safety, just as you would when jacking up and working under a car. Always park...
-
They could save the entire cost of the loader seal by eliminating it entirely and the cylinder would still not leak down. The cylinder...
-
ejb11235 reacted to nbryan's post in the thread Debating purchase of a used BX2830 snowblower with Like.
These blowers have a very effective set of shear bolts that have protected my very similar B2782B 63" blower for 7 winters now...
-
ejb11235 replied to the thread Debating purchase of a used BX2830 snowblower.This is great advice. Since I posted my initial thread, I've done a complete 180 on my desire to have a snowblower. You may be familiar...
