Donystoy's latest activity
-
DMost loaders I've seen are designed with the torque tube passing through both arms and welded on both sides. Cutting holes in the arms...
-
DI was watching the GP outdoor YouTube channel where it was mentioned that the output shaft on the "K connect" system can slide forward...
-
DDonystoy replied to the thread LX2963 Snow blower not level from left to right.You can also run a tape measure along either side of the front of the tractor vertically in the area where the "K" connect fastens to...
-
DMy B2782B snowblower lift cylinder began leaking and could not hold position under load anymore, so looked into taking it apart so I...
-
DDonystoy replied to the thread LX2610 block heater location.Had my B7200 from 1985 until 2022 with the first 35 years in an unheated building. No heater or fuel additives. Never any issues...
-
D1/4 or 3/8 is all you need, 1/2 is way to big and bulky.
-
DDonystoy replied to the thread LX2610 50hr shop vac question.I did the vacuum trick with a small shop vac sealed to the fill opening using plumbing fittings and a rubber ring and nothing else...
-
DDonystoy replied to the thread Tire foaming question(s)....Has anyone here done it?.I have never had any tires foam filled but I did try Kelver liners on my old B7200. I was frequently getting flats on my front turfs...
-
DDonystoy replied to the thread LX4020 Recall.I would certainly think that Kubota would want this issue corrected from a liability issue regardless of whether the owner uses the...
-
DDonystoy reacted to Mr. K's post in the thread Should moderators be elected by membership? with
Like.
Hey everyone, Mr. K here, sorry I'm late to the party. Will toss my perspective in here - 1/ Appreciate armylifer (and others) speaking... -
DDonystoy replied to the thread LX2610 front weights.My service manual shows the bracket but no part number. Your Kubota dealer should be able to get you the number and order one for you...
-
DDonystoy replied to the thread Spring is coming....too early to get out of "Snow Mode"?!?!.No need for me to remove the blower or blade since I can only drive on the driveway until the fields are dry. Might be able to do a bit...
-
DDonystoy replied to the thread Is a quick hitch worth it when you have adjustable links.I would buy a quick hitch if it did not add any length to the 3 ph and had the ability to adjust the width. I have numerous attachments...
-
DDonystoy replied to the thread looking to buy a B6000E 2wheel drive 10 spline PTO yoke..Try Weasler driveline catalog. They might have what you need. I think they even carry 10 to 6 spline adapters if you have to go that route.