dlsmith's latest activity
-
And by all means, don’t open any attachments (.pdf, .doc, .xls, etc) that could have some bad juju embedded within the attachment. -
Look at the sending email, bet it's not messick's email. Email scammers are getting high tech and they are scamming everyone.
-
dlsmith replied to the thread Daily Chuckle.I had pretty bad trigger finger about 15 years ago, but after I sold my trucks and don't stress my hands nearly as much, it eventually...
-
-
-
A few years older than you...still have plenty of grip strength. But I've developed what the Doc calls "trigger finger"...sometimes...
-
I don't get frustrated at people not being able to do what they used to do, but I DO get frustrated at people not being able to do what...
-
-
-
dlsmith replied to the thread Well "Blow me down!".I don't remember the brand, but I bought a bottle of that solution and used it to refinish a lot of bolts on my Nova when I was...
-
dlsmith reacted to lynnmor's post in the thread What did you do to or on your Kubota today? with
Like.
McMaster-Carr is a good source for clevis pins. -
dlsmith reacted to NCL4701's post in the thread What did you do to or on your Kubota today? with Like.
If you have a decent local hardware store, get a 5/8” grade 5 bolt long enough the unthreaded part is at least 2 1/8”. Cut it to length...
-
dlsmith reacted to Old Machinist's post in the thread Running 110 volt tool from block heater cord. with Like.
If the cord has a female receptacle it's connected to an inverter. A block heater should have a male plug end.
-
I'm very sorry for your loss. My deepest condolences. I promise things will get better 😁
-
Over the years I see a lot of jokes about 10mm sockets. Never really got them. Well today I was changing out a tensioner pulley and it...
