Recent content by dgtvrpepair

I would grease it at least every 20 hours. That shaft extends and retracts more than you think on even flat ground. Don’t forget all the grease points on the shaft including the plastic covers that have a grease place that is plastic. Don’t miss the one on the shaft that extends and retracts...

Check the simple ones first. Is the parking brake on? Seat safety switch.

Looks like the same design. I will look into that if I get another attachment that needs the other halve. Thanks.

I have the same l2260 on my l4760. Yes they are over priced. It is crazy how easy and smooth it connects the hoses. No oil drips. I was tired of fighting the connections. Had tried the pioneer style and the flat face.

Look at tractor supply. They make an extension for about 30.00. Best to put it on the end of the shaft that goes in the implement.

I don’t that you can. The frame on the unit is longer with the 72” and the hanger points would be in the wrong place.

Most likely the temp blend actuator is bad. It directs air flow to heater core for heat.

I have the same seat. It had been that way since new. That is just how they do

it is probably the pto solonoid

I just installed the Kubota kit after research and it is really good. Someone posted instructions on here for a l6060 which is the same kit and it helps a lot with the installation.

My l4760hstc does the same thing and it is normal. Mine has done that since new.

I would look closely at the pro shaft on your implement. It should slide in and out easily. Also check to see if the shaft is too long when raising and lowering the implement. If it is too long and needs to be cut it will put extreme forces on the tractor pro when it bottoms out.

A cover that slides off it.

See if it has a plastic cover that is solid over it.