Recent content by Deweym3088

I am replacing the whole assembly. I’m obviously on the low end of a steep learning curve. I’ve split and replaced clutches in older tractors but not the newer models. The people I ordered from only asked for the model number and obviously sent a clutch for a different model. The pilot bearing...

I have the L3901D. I ordered the part from Kentucky Clutch and just gave them my tractor model number. They are a clutch rebuilder and may have been a mix up on their end. The local dealer was just too high at 2200 just for the clutch pack.

Thank you all for the replies and info. I’m having trouble using the site because of all the pop up ads. Guess I’ll move to paid subscription. I got the tractor split and installed the pilot bearing and torqued the flywheel. Then when I went to install the new clutch pack it was too big. It...

I guess that’s is what I was asking. I had seen somewhere that said to be sure and mark the splines and be sure it went back in exactly as it came out or bad vibrations and damage would result. Thank you so much for your reply.

I just split my Kubota 3901 at only 224 hours. Maybe I’m just a bad operator. Not sure. Finally figured out the front driveshaft removal and drove out the front roll pin. When I split the tractor the drive shaft came out of the back splines. I did mark the the front of the shaft but not sure if...