Dave_eng's latest activity
-
In the 'electrical diagrams' sub folder, post #13, there's the BX23S wiring that White tiger posted. it 'should' or 'may' be very close... -
Dave_eng reacted to whitetiger's post in the thread L3130 HST Tractor no electrical power with
Like.
The seat switch does not control the lights on the dash. Open the hood and look at the Positive battery cable, there should be a smaller... -
Dave_eng replied to the thread B2710 hydraulic system not working after changing fluid and filters.Could you have overfilled the trans? Next time while doing the blowing, plug the vent line outlet with your finger. Dave
-
Dave_eng replied to the thread B2710 hydraulic system not working after changing fluid and filters.Another trick which has helped some is to use a shop vac on the blow setting and pressurize the transmission thru where you added oil...
-
Dave_eng reacted to 007kubotaguy's post in the thread L185DT: Wrong bolt in transmission? with Like.
If you need a bolt send me a pm and I will send you one.
-
Dave_eng replied to the thread K725KH no start.If you followed Kohler's instructions and their motor does not work, this means in their world you have determined the problem lies with...
-
Dave_eng replied to the thread K725KH no start.I have a Toro with a Kohler Engine. I always find Kohler's web site is very useful when it comes to no start situations. Kohler CV742...
-
-
Dave_eng replied to the thread This is my 3pt ballast...............David I make this comment because I worry too much. If your log pulling is placing loads on your tractor above the level of the draw bar...
-
Dave_eng reacted to ruger1980's post in the thread Kubota mini excavator KX41-2V left track issues with Like.
I would recommend using the right travel valve to test the left travel circuit. The auxiliary spool is very different so it is not a...
-
Dave_eng replied to the thread This is my 3pt ballast...............Nice work! Since you are working with solid material, do you do anything to get welds which involve the complete cross section of the...
-
Dave_eng replied to the thread B7100 Ignition Fuse Blowing Immediately.What model of B7100 do you have......HST or manual transmission. 4x4? Go to this site and download the Workshop manual for your tractor...
-
Dave_eng reacted to lugbolt's post in the thread Tractor (L2501) not starting. Safety tripped? with Like.
oftentimes on the HST models, we tend to just move the PTO lever toward the operator expecting the lever to return to "off" on it's own...
-
Dave_eng replied to the thread B2601 Belly mower blades spinning on spindles.My experience has been that once the blade starts spinning, it elongates the blade hole and no amount of Belleville washers and torque...
-
Dave_eng replied to the thread B2601 Belly mower blades spinning on spindles.It is time to learn about BELLEVILLE washers. Wkipedia has an excellent article about the many ways washers can be oriented to achieve...
-
Dave_eng reacted to whitetiger's post in the thread Diesel engine sucked up water! Now what? with Like.
Did you remove the water logged air filter? Next step is to perform a compression test by removing the 3 glow plugs and testing through...
