Chanceywd's latest activity
-
Chanceywd reacted to Bmyers's post in the thread What did you do to or on your Kubota today? with
Like.
Weather finally allowed for some work to be completed at the farm. Finished the first mowing of the season. Then turned the attention... -
Chanceywd reacted to McMXi's post in the thread What did you do to or on your Kubota today? with Like.
Yesterday while using the M6060 I noticed that the hydraulic shuttle lever felt a little "off". Upon closer inspection I noticed that...
-
Well....I've certainly done the same thing a time or two. All of my vehicles are capable 4wd and most have winches on them (for self...
-
Yep, I've been driving 4wd vehicles of one type or another since I was 15 yrs old (55 yrs ago). Along the way....I've learned when its...
-
Chanceywd reacted to 5280GearHead's post in the thread L3240 ( HELP!!!! ) POWER LOSS, SURGES and BLUE SMOKE with Like.
Update: Installed a new fuel pump and that my friends fixed all the power loss issues. Even at 8700 ft elevation the newly Turbocharged...
-
Chanceywd reacted to 5280GearHead's post in the thread L3240 ( HELP!!!! ) POWER LOSS, SURGES and BLUE SMOKE with Like.
You could be right. After applying a head psi to the fuel tank during the power Surging operation, the power surging clears up and then...
-
Chanceywd reacted to North Idaho Wolfman's post in the thread L3240 ( HELP!!!! ) POWER LOSS, SURGES and BLUE SMOKE with Like.
Your fuel also looks frothy??? If your starving the injection pump that bad it really shouldn't run at all. Pull the fuel line feeding...
-
Chanceywd reacted to North Idaho Wolfman's post in the thread L2350DT flywheel resurface or replacement? with Like.
Yep they put the rivets in backwards! I've gotten plenty from this place and they've always been good...
-
Chanceywd reacted to DrakeRemoray's post in the thread L2350DT flywheel resurface or replacement? with Like.
Well we figured it out. Pressure plate is being held off too far and not allowing it to engage fully when bolted down. The rivets are...
-
Chanceywd replied to the thread frozen backhoe pins.I'm looking at it this morning and wondering if with the tires off, could you use a magnetic base drill on the frame mount and drill the...
-
You're right. I was focused on the pins moving and didn't note the flange deflection as I jacked. The pins are so frozen on the outboard...
-
A port-a-power was about the worst thing to use in this situation, you probably see that now. I have wasted so much time trying to soak...
-
From your last pics, it looks like the top brackets on the backhoe itself have been bent for some reason? that would explain why the...
-
Any conversation about disassembling "slip-fit" pins should include possible consequences of improper bigger hammer use. Over the years...
-
I have removed some large stuck cylinder pins from cranes, I would weld a long bar to the pin and use a porta power, jack or another...