Caden's latest activity
-
I think GreensvilleJay point is very important - why only 34 hours (typo maybe)? Buyer beware! Just make sure it's not a scam (who's... -
impossible to advise without more info. I would be completely guessing otherwise. Carfax says over 1/2 million ultra low mileage / low...
-
Hey... I had that same puny chain with my BX25D. My tractor pulled it so hard, the chain snapped!
-
It would give the same results as the other end of the line. ;)
-
https://www.youtube.com/shorts/q_72FH7sr_w
-
Caden replied to the thread L2502 wont start.Can you loosen the lines right when they leave the pump?
-
Caden replied to the thread L2502 wont start.It seems like now would be a good time to change the cartridge filter in the sep. According to this diagram there is a bleed screw next...
-
-
Caden replied to the thread rotary cutter driveline grease.I'd definitely grease it that often. Not only does it move quite a bit, but if it sits a while during non-use, they love to seize up...
-
You do not have to remove the implement end of the drive shaft. If you just pull the drives towards the front end it will come apart...
-
Caden replied to the thread Should reverse end of HST pedal contact stopper bolt?.Mine does. I assumed that was what it was for, to prevent the internal mechanism from bottoming out.
-
Looks like you might be able to bribe those inspectors with a cheeseburger ... !
-
Caden replied to the thread Safe way to remove a tree.That was 11 seconds I can't get back. I'm so sick of the sorry people in the world using AI to make this garbage.
-
My version of a dolly for the BH-77 Backhoe for my L2501: Full build series (with testing) here: Part 1: Part 2: Part 3: Super...
-
I just do it a simple way... I watch when it quits moving go a tiny bit more and then adjust it. Has worked perfectly for me for many a...
-
Caden replied to the thread Mowing Question G1800S.As a general rule of thumb, anti scalp wheels should be 1/4 inch off the ground when deck is at the desired cutting height.
