Bee-Positive's latest activity
-
BBee-Positive replied to the thread RTV recall.After reading the notice again I see the ball joint "can loosen and separate". Not sure if they are talking about the stud/castle nut...
-
BBee-Positive replied to the thread RTV recall.Your first point - EXACTLY! Second - ball joints that I have seen fail, come apart, the castle nut and pin are still connected to the...
-
BBee-Positive replied to the thread Recently acquired Kubota T1400 with HST won't drive forward or reverse.Welcome aboard Clacur!!! Quite the old girl you got there. Never owned a T1400H but here's what I'd be looking at first. So you have a...
-
BBee-Positive replied to the thread RTV recall.Ball joints allow the wheel to pivot so it's "technically" part of the steering system. So is the tire and lug nuts following that line...
-
BBee-Positive replied to the thread B1750 Mower Issue.In the third picture you posted the rear tractor wheel looks like it's a bit farther out than the fender, it may be just the angle the...
-
BBee-Positive replied to the thread Can’t connect loader hydraulic latch BX.The fluid has gotten larger due to temperature changes and the fluid’s coefficient of thermal expansion. Maybe try it first thing in...
-
BBee-Positive replied to the thread BEE KEEPING.I like the finger slots / hand grips. Did you router those yourself?
-
BWe thought it would BEE more like a home if the girls had a 3 season room / pavilion…sort of like a she-shed 😉 to make it feel more...
-
BBee-Positive replied to the thread M105x fuel filter not sending fuel to injector pump.My first guess - when was the last time you replaced the fuel filter? Put a new one in and see if that fixes the problem. On my little...
-
BBee-Positive replied to the thread Wolverine sickle bar attachment.I don't have one and have no experience with one but according to Tractordata.com the L5030 has a pump flow of 9.8 GPM. Wolverine's...
-
BBee-Positive replied to the thread Can I keep ballast box up while mowing with BX1880?.Free at kubotabooks.com
-
BBee-Positive replied to the thread Can I keep ballast box up while mowing with BX1880?.On page 55 of the WSM there's a picture of how to keep the 3 pt. up while mowing. Disconnect the pins from the upper arms and put them...
-
BBee-Positive replied to the thread I’m confused..This should be covered in the users manual. Get one, and also a Workshop manual. READ them both. The lever on the right raises and...
-
BBee-Positive replied to the thread New L3902 - 17h - Lost all hydraulics.3 weeks old - Warranty / Dealer problem. Stand your ground, don't let them tell you it's your fault - unless your not telling us...
-
BBee-Positive replied to the thread Bx2660 won’t shut off.Kubotabooks.com has it.
