Bee-Positive's latest activity
-
BBee-Positive replied to the thread FEL while mowing..Ditto - easier to maneuver around the house and deck, also safer on the slopes I have - so it depends on your situation. It's rained 21...
-
BBee-Positive replied to the thread Stupid Question - Engine oil level 1997 L2350F.Buy the way - the only "stupid question" is the one you don't ask. The best way to get an answer is to ask. I've never been put down...
-
BBee-Positive replied to the thread Stupid Question - Engine oil level 1997 L2350F.Mark #2 is full Mark #3 is low Mark #1 you'll fine out why they put the FU in FUN!
-
BA woman, frustrated because her husband was late coming home from golf yet again, decided to leave a note that read, "I've had enough...
-
B$50 golf cart roof: I bought two at the same time and installed one on my Kubota ZD326 zero turn.
-
BBee-Positive replied to the thread Kubota b5000.Opa Antonio! If I am not totally mistaken the rough English translation is... Good morning Acquired Kubota model B5000, I would like...
-
BBee-Positive replied to the thread 1996 L2350 No Start.Advice I often see on OTT for any tractor model is to check all your ground wires (especially after almost 30 years). Make sure you're...
-
BBee-Positive replied to the thread Canopy/sun shade options or designs?.Hey Sammy - nice rear view mirror. How do you like it? Any pro / cons, i.e. does it vibrate when the tractors running, cost, field of...
-
BBee-Positive replied to the thread B1750 Mower Issue.Here's the specs for MMM's that fit your B1750 according to...
-
-
BBee-Positive replied to the thread B1750 Mower Issue.Given the age of the tractor do you remember the last time the deck had any regular maintenance? Clean it up and as SDT said, GREASE it...
-
BBee-Positive replied to the thread BX2200 belly mower.I've never driven up on ramps to put the mower on. I have raised the bucket, snug the MMM up to the wheels, lower the FEL to raise the...
-
BWhen I made a canopy for our 19' steam launch, I bent 1/2" EMT into 3D curves; that's really not needed here. I followed the design of...
