007kubotaguy's latest activity
-
I bought a loader for a Massey and adopted it to an L305 a few years back. I had to build the entire mounting hardware. You have to... -
007kubotaguy reacted to North Idaho Wolfman's post in the thread 1980 B6100 4x4 - Looking for loader. with
Like.
Yes loaders for B6100DT and B7100DT's or really any of these 40 year old tractors is really hard to say the least. One big issue is the... -
Welcome to the forum. I notice you reside on the correct side of the state line! I'm down south of Olathe 25 miles. Mikester may have...
-
007kubotaguy reacted to JohnDB's post in the thread M4500DT front diff input shaft and axle pivot with Like.
(This may also be relevant to M5500DT and M7500DT) The front axle pivots aren’t greaseable in stock form and when they wear, they put...
-
007kubotaguy reacted to Russell King's post in the thread Repairing or replacing a battery box with Like.
See if @007kubotaguy has one from his salvage. I got wheels from a L260 if my memory is correct. (Forwarded and removed by MOD) part...
-
007kubotaguy replied to the thread M4050 PTO grinding.The PTO clutch lever should have about 1" to 1 1/2" of free play. If it has too much or too little adjust the linkage. When the PTO is...
-
Yes, experoence with both. The Chief valves are house branded P40 imports avaikable for less from other sources. The Wolverine valves...
-
“Step one, rescue vintage worn out rasp_Step two, twist one end up a bit so you can hold onto it_ (Over the horn, using tongs and a vise...
-
007kubotaguy replied to the thread Kubota L4150 Hydraulic filter screen.A common problem with this tractor is brake lining flakes off and plugs the suction line. I would remove the suction line from the side...
-
Looks good, but I'd still make some kind of shield. Thin metal under the unit and use a couple of the bolts showing in the first...
-
I've seen a lot of fuel filter mods, here's mine. I decided to mount the Kubota 15521-43018 filter housing behind the loader frame. The...
-
007kubotaguy reacted to North Idaho Wolfman's post in the thread M6800 starts and shuts off repeatedly with Like.
BAD switch
-
It was PSB-1981-006:
-
007kubotaguy replied to the thread Rtv x900 fuel filter.If you have replaced the o-rings and it's still leaks chances are you will need to replace the plastic canister. Be careful these are...
-
007kubotaguy replied to the thread Oil leak.That's it. I installed lots of them.