007kubotaguy's latest activity
-
007kubotaguy replied to the thread v1902 - fuel not leaving fuel pump in 2 of the 4..Are the delivery valves tight on the pump. This is the part the injector lines attach to. If they are lose it wont pump fuel. -
007kubotaguy replied to the thread Kubota L2550 4WD Front Axle Question.This is not a difficult job to replace the o-ring. The hardest part will be removing the tie rod from the outer drive so you can remove...
-
007kubotaguy replied to the thread L2850 axle question.You should not need any sealer on the rubber plugs. Just be sure that everything is clean and shiny before installing. Including the...
-
Other reasons that could be why is not working. If the Flywheel has been turned. Bad pressure plate Disk bad (too thick) Wrong parts...
-
Had a customer with same issue. Verified everything was correct and adjusted correctly. Ended up being a crack in the clutch fork...
-
007kubotaguy replied to the thread M6800 starts and shuts off repeatedly.I take care of quite a few M6200, M8200 and M9000. I have replaced the key switches on almost all of them. I keep an extra in my service...
-
You cannot put a tee in a pressure line. Fluid will always take the path of least resistance so youll have flow but no pressure. You...
-
007kubotaguy reacted to North Idaho Wolfman's post in the thread How many Members here at OTT have met other OTT Members in person? with
Like.
"I don't know half of you half as well as I should like, and I like less than half of you half as well as you deserve" -
007kubotaguy reacted to North Idaho Wolfman's post in the thread How many Members here at OTT have met other OTT Members in person? with Like.
I think I've meet a couple dozen or so over the years.
-
007kubotaguy reacted to BX25D Rookie's post in the thread How many Members here at OTT have met other OTT Members in person? with Like.
I had errands to run today. I also stopped at the local Tractor Supply store in town. I'm looking for some bolt on "D" rings for my...
-
007kubotaguy replied to the thread Diaphragm pump identification.Looks like a old Hypro. Are there any part numbers cast into the air dome?
-
It's the valve stem binding/seizing in the valve guide when hot, or the valve spring achieving coil bind. I built a race car motor years...
-
I am pretty sure it will be difficult to get new rims. There is a member (in California) that has a lot of L series parts (salvage...
-
As Wolfman said - you will get a bump - then smooth then a bump. AS you send the armature through the permanent magnet - the attraction...
-
007kubotaguy replied to the thread L2201DT rear reduction gear lube?.The transmission rear differential and the two final drives should all be one common fluid. A good quality tractor hydraulic fluid. I...