My M7040 will not move. I have tried it in all the gears, forward and reverse and in hi-lo range. it feels like it is either high or low range and the forward and reverse are going into gear but when I release the clutch out it goes no where.
I had just pulled a disc through the field to see if it was dry enough to work ground. it was too wet so I changed the bucket and stopped at the shop. when I came out it would not move. the clutch goes to the end of its travel and I can see the linkage rod move.
any ideas?
I had just pulled a disc through the field to see if it was dry enough to work ground. it was too wet so I changed the bucket and stopped at the shop. when I came out it would not move. the clutch goes to the end of its travel and I can see the linkage rod move.
any ideas?