L3750 3 point

[Cards1965]

Does anyone know of an aftermarket solution for L3750 3 point hitch? Thanks

 

[North Idaho Wolfman]

Give me the distance from the center of the rock shaft to the center of the lift arm pins.

Also give me a couple more pictures below the axle, it looks like your missing some other parts you will need.

DO NOT OPERATE that tractor!!!
The ROPS and the fenders are NOT ATTACHED and will simply fall off if you hit a good bump.

 

[Cards1965]

Give me the distance from the center of the rock shaft to the center of the lift arm pins.

Also give me a couple more pictures below the axle, it looks like your missing some other parts you will need.

DO NOT OPERATE that tractor!!!
The ROPS and the fenders are NOT ATTACHED and will simply fall off if you hit a good bump.

I will get this pic and measurement tomorrow. Yeah, I saw they weren’t attached when I was looking to buy. I’m currently trying to get it all back together. Thanks for the warning though, I appreciate it.

 

[North Idaho Wolfman]

You need these plates (yellow), the tab and hole on the bottom (red) is critical as it needs to line up with the pin for the lower arms, they are for the sway links.
If they don't line up with the link arm pin the dimension of the sway links change as you lift it, and that's bad.

 

[Cards1965]

You need these plates (yellow), the tab and hole on the bottom (red) is critical as it needs to line up with the pin for the lower arms, they are for the sway links.
If they don't line up with the link arm pin the dimension of the sway links change as you lift it, and that's bad.

View attachment 151853

They’re actually laying right right under the PTO shaft. Why they were off, I have know idea. This was actually brought to my house on a trailer 30 miles away. I don’t know how it stayed upright.

 

[Cards1965]

They’re actually laying right right under the PTO shaft. Why they were off, I have know idea. This was actually brought to my house on a trailer 30 miles away. I don’t know how it stayed upright.

The measurement I’m getting is 12” from center of rock shaft to the center of the pins on the lift arms.

 

[North Idaho Wolfman]

The measurement I’m getting is 12” from center of rock shaft to the center of the pins on the lift arms.

Are you sure?
I get 16" on my smaller L3450.

 

[Cards1965]

Are you sure?
I get 16" on my smaller L3450.

View attachment 151879

I’m sorry, I was completely measuring in the wrong place. Thanks for the pic. I will get the correct dim in the morning. Even at 60 I’m a newbie.