L3750 3 point
- Thread starter Cards1965
- Start date
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Give me the distance from the center of the rock shaft to the center of the lift arm pins.
Also give me a couple more pictures below the axle, it looks like your missing some other parts you will need.
DO NOT OPERATE that tractor!!!
The ROPS and the fenders are NOT ATTACHED and will simply fall off if you hit a good bump.
Also give me a couple more pictures below the axle, it looks like your missing some other parts you will need.
DO NOT OPERATE that tractor!!!
The ROPS and the fenders are NOT ATTACHED and will simply fall off if you hit a good bump.
I will get this pic and measurement tomorrow. Yeah, I saw they weren’t attached when I was looking to buy. I’m currently trying to get it all back together. Thanks for the warning though, I appreciate it.
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
You need these plates (yellow), the tab and hole on the bottom (red) is critical as it needs to line up with the pin for the lower arms, they are for the sway links.
If they don't line up with the link arm pin the dimension of the sway links change as you lift it, and that's bad.
If they don't line up with the link arm pin the dimension of the sway links change as you lift it, and that's bad.
They’re actually laying right right under the PTO shaft. Why they were off, I have know idea. This was actually brought to my house on a trailer 30 miles away. I don’t know how it stayed upright.
