L2350DT flywheel resurface or replacement?

[North Idaho Wolfman]

OP, I'd machine that flywheel in a heart beat and never think twice. If you take it to a good machine shop, they'll likely also have spacers you'd add between the crank and flywheel that is the thickness of the material removed.

He doesn't need the flywheel machined, he just need a pressure plate that the rivets have been installed properly.

 

[Russell King]

Well we figured it out. Pressure plate is being held off too far and not allowing it to engage fully when bolted down. The rivets are holding it off. Going to order Kubota branded and get her going

Well the good thing is that you already have it apart so is easier to fix now!

It is good that you were observant enough to see what the problem was!