Search results

I will try and make this long story as short and accurate as possible. A friend asked me to complete a engine rebuild that someone else started but couldn’t complete. They had completed the lower half. Pistons, rings, bearings, with the timing gears installed and timing cover on. I installed...

Thanks for all your suggestions I’ll report back when I figure it out

I have a b7200 the battery is not being charged (12.5 volts) how do I test the generator it has two wires coming out of it.

Thanks for the info, I was afraid of that.

yes I have that picture but what I need to know is in order to replace the bracket the pto shaft that goes through it must be removed, how does the pto shaft come out, will it come right out the top ? it doesn't seem likely with the speed change lever on the bottom. or does it come out another...

need some help with my l2650, trying to remove the pto shift lever. does anyone know how it comes out of the transmission.

Ok thanks, just seems so wasteful. Also I hope they don't drop the ball on any respect or I'm screwed.

Need some help with my rtv my head has a crack in it. I taked to the dealership to order a new one and they sold me on a new engine. But they said before they could place the order I had to e-mail them a picture of the engine with a 2 inch hole I had to drill into the block to verify it was...

P/s issue figured out. I took both lines off controll valve like you suggested I have fluid out of only one hose at a time while turning in ether direction. But one thing I noticed was with one hose connected to cyl and one hose off while turning in one direction fluid would come out of other...

with the rtv off and the wheels off the ground the wheels will not turn when you turn the steering wheel.

thanks, i have about 1300 psi at the pump thats with the steering wheel all the way to rt or left. i also have that at the steer cyl on both hose in one dirrection or the other. i had heard the steering on the rtv has the type that allows you to steer when you loose assist. is there a way to...

Thanks for the reply,it's a rtv900g6-h65107. Thanks for the help I'll ck it out if it comes out both hoses. Also what psi should that pump put out?

Need some help on a problem with my 01 rtv900. Steering seemed to be working ok stopped it one day came back an hour latter and could only steer to the rt and not very well. Jacked up the front end everything seems to be connected. Wheels will not move with either the eng running or not. Flushed...

Thanks for the info. Where would I find the serial #of the engine !I need a head gasket

I have a zen-noh zl 2202 fd can any one tell me what that would be in the kubota line

ok so if i have fuel to the injection pump and no pressure out of the injection pump whats next ?-the lever that kills the engine does that change the injection pump operation ?.

i have a L 355 the tractor would not start very well, i found the primary pump diaphragm cracked so i replaced the whole pump assembly. i am following the bleeding procedure.but have a question. is the fuel pressurized from the injection pump or from the injectors.

I know some tractors have a rate of drop knob for the 3point sometimes it accidentally gets turned and won't allow it to raise

sorry got ahead of my self. b2150hst

I have a leaking seal at the imput shaft on the hst pump. How do I get at it I think I have to split the tractor. And where can I find a wsm Manuel .