Recent content by trackman23

Thx folks. I may try to add RTV as mentioned to a factory gasket. Upon further investigation, the times of my Tiller must have picked up a rock and sheared off the backend of one of these cover bolts, which also bent the metal a bit, so I will need a little bit of extra help from that RTV to...

I have a 6’, lowrey rotary tiller with a leaky side gearbox that needs to be fixed. Is this a repair that is best made with a factory, one piece gasket or with RTV? thx!

Thanks folks! i think I might go for something inexpensive $250-$350 to start as someone suggested and see how I end up using machine for a while then upgrade when it breaks. I know a lot of folks online seem to like the PrimeWeld welders and they have a few plasma cutters under $400 with...

I have an IR 5HP compressor; 18cfm @ 90 psi according to the spec sheet.

Ok folks, I am not sure that I "need" a plasma cutter but since it is black friday, /cyber Monday season, this mightbe the time to get one just in case I plan to make some chimeneas / fire pits / fire rings from old propane tanks and other scrap I can get my hands on and at some point I may...

Technically 39-40.5 according to the AI search! That raises an interesting question. when implement manufacturer specify horsepower range are they referring to the PTO power or the power of the machine?

I have an MX4800 and am considering getting a chipper for it so I have the option of making mulch with limbs and scrub rather than always burning them. What is the largest chipped I can reasonable run on my 48HP machine and who makes a decent chipper? Thanks!

Thx folks! The battery was fine, and the issue was corrosion in the signal wire connector. It is a lot easier to troubleshoot during daylight hours and when it isn’t raining! crazy how it decided to give up in the middle of a project and not after sitting unused for an extended period of time.

I am clarifying things to be sure that folks understand that what I am seeing is happening under very low loads.

I pulled all the fuses and reinstalled them…no corrosion and nothing blown. I hear you about corroded cables and terminals but what it is doing right now is happening under essentially zero load. It is only with the ignition on that It’s behaving like this and when I try to start it, it does...

I tried to paste a video to describe what I’m seeing, but it looks like I can only upload photos. I have a MX 4800 that I have been using all day without issue and I turned it off just about an hour ago to grab a drink of water and when I jump back on it simply turning on the ignition made the...

I just picked up a 2007 Kawasaki Mule 3010 trans diesel and would like to recover or replace the two bench seats. The foam seems fine so unless it is a ton of work I prefer to recover. I am looking for recommendations on who sells good quality replacement covers or seats? When searching for...

$1800 for a replacement so I think I'll search for some tractor cluster repair shops online. Thx!

Hi folks, I’ve got an MX4800 and it is getting almost impossible to read the LCD display that shows the hours, error codes, etc (pictured). What is the best way to fix this? thx!

Thanks folks, lots of good suggestions! I had no idea how much of a price premium they have on the electric UTVs which put them out of my range. I may just pick up a used golf cart with a bed and see how that works for us or a used Mule and make a little noise.