TheOldHokie's latest activity
-
TheOldHokie replied to the thread 1999 M120 Kubota 3pt lift lockout (2026 thread).Lets summarize what we think we know Based on the last few rounds of testing it seems we now have solid flow into (P port) and out of... -
-
TheOldHokie replied to the thread 1999 M120 Kubota 3pt lift lockout (2026 thread).OK. Have we established with certainty that inlet oil is flowing throughvthe valve and into the filter? Do you have the engine running...
-
TheOldHokie replied to the thread 1999 M120 Kubota 3pt lift lockout (2026 thread).You say "spools" . You should only be pressing the lift spool solenoid. Dan
-
TheOldHokie replied to the thread 1999 M120 Kubota 3pt lift lockout (2026 thread).I think all of the problem is in "the block". Going forward can we call it by its proper name - its the "draft control valve".
-
TheOldHokie replied to the thread 1999 M120 Kubota 3pt lift lockout (2026 thread).Crap - I was hoping that would do the trick. Disconnect both solenoids and try manual activation again.
-
TheOldHokie replied to the thread 1999 M120 Kubota 3pt lift lockout (2026 thread).I think we have found the problem. I dont think air should be coming out of that second port when but you pressurize 3.. Thats where the...
-
TheOldHokie replied to the thread 1999 M120 Kubota 3pt lift lockout (2026 thread).Forget the remote flow test for now. Repeat the compressed air test on the draft control valve. Apply air to port one and if you get...
-
TheOldHokie replied to the thread 1999 M120 Kubota 3pt lift lockout (2026 thread).How can you be getting that volume out of port 1 with nothing going into the filter (port 3)? Dan
-
TheOldHokie replied to the thread 1999 M120 Kubota 3pt lift lockout (2026 thread).What model loader? Hook a hose to one of remotes and check how much flow you get pumping into a bucket
-
TheOldHokie replied to the thread 1999 M120 Kubota 3pt lift lockout (2026 thread).How much flow are you getting with the tractor running - a dribble or enough to make a real mess? Are you operating the remotes without...
-
TheOldHokie replied to the thread 1999 M120 Kubota 3pt lift lockout (2026 thread).Just to be clear - when cranking the tractor there is no oil coming from any port in the hydraulic cover? If so start the trsctor and...
-
TheOldHokie replied to the thread B7200 hydraulic steering.Looking good. Just FYI Kubota used a solid splined coupler and if needed a flex coupler on the outboard end of the shaft. Dan
-
TheOldHokie replied to the thread can a person put a higher output hyd pump on a L4310.Yes but at what cost and to what end? Dan
-
TheOldHokie reacted to North Idaho Wolfman's post in the thread Bx25 hydraulic pressure loss with
Like.
This is why I was needing more information: #1 issue with these when this happens is that the BH loop is not allowing flow. Remove... -
TheOldHokie replied to the thread L35 TL720 Aluminum bucket cylinder head gland stuck! Replacment cylinder thoughts?.Looking good. I think thats going to be a better solution than reworking those old cylinders. Dan
