Recent content by Tarmy

It is really something you don’t want to happen…if needed, pay someone else to birth the clutch.😎

Christmas present inbound!!!!

I have a Miller 625 extreme…my cuts with dried air are vertical clean. I use a setting that is a for a slightly thicker cut than I am doing. my cut lines are straight up and down thru the piece…yours appear to be too short, hence the curve. The key is DRY AIR and enough of it…keeps that cut...

You rock guys are lightweights…these are the rocks I got outa digging just a little area to widen my trailer storage…

Made that…version 2. I actually has a fitting that I sue on my 28’ fiberglass heavy ladder. There is a similar fitting the goes on the bucket…so I just carry that big ladder where I need it to be…you can see it between the upper two shovels if you zoom in. It rides in the vertical tube…when I...

Do not drill the ROPS. Look at that pic carefully and you will see a bolt on plate I made to stabilize the tool box on the fender…

Here…

All about the attitude. I am 67 and still skiing a bunch, maintain basically everything, 3 homes, boats, trucks, cars, help friends when needed and financially we and our kids are set for life. At 65 I started to notice that I couldn’t work hard for 10-12 hours as I used to…now it’s about 8...

I have 435 hours of flawless use over 17 years. Change fluids and service accordingly to manual. This tractor has worked great. I used it for about 3 hours a day…over the last 4 days. Two of those days I would start it no issues. The other two, I would start it right up and it would stall...

I had the Titan ones and always was apprehensive when I went to use them. Got tired of worrying and got a QA set up for doing it correctly. Got a few other implements as well. I should have got the QA set up years before…

I use my dump trailer that is 14’ for my L series. I have two rear Jack stands on the trailer and only load/unload with it attached to a 3’4 ton truck. The other thing I did was weigh the tongue and make a location for the center of the rear tires so I know when the load is where I want it. I...

I’ll do it…I need a new….nevermind.😎

88 yesterday…90 today…

Get TnT and you will thank me later. If you are going to have stuff added…get both valves and rams now. Total pain in the ass otherwise.

when the power is out the gas stations can’t pump gas…around here anyways. Also, this damn state has basically made it impossible for commercial businesses to meet air quality standards to get a permit for one.