Sidekick's latest activity
-
Sidekick reacted to Rdrcr's post in the thread L2501 Turbo: A Journey Defined - The tractor, The comparison, The modification, The results... with
Like.
^^^^^ Not yet but, we hope to get it on the schedule soon. Mike -
I added that right side handle (inner and outer) to the MX a couple of years ago. Definitely worth the cost at around $300.
-
The picture from Messicks sure looks like it comes as part of the handle assembly. It is likely either cast into the plastic or...
-
Missing the second insert ... Just gonna buy a whole new handle ... I'll call and see it come with it installed? Should in my opinion...
-
Sidekick reacted to Runs With Scissors's post in the thread Got some advice for a “3 way” ……….(from my wife…;)…..(she thinks it’s better in the front, not the rear?) with Like.
Yep, I couldn’t agree more…... especially for a beginner like myself, they are invaluable. The 2 that I have on my lathe and “Chi-Com...
-
Sidekick reacted to X-Pup's post in the thread L2501 Turbo: A Journey Defined - The tractor, The comparison, The modification, The results... with Like.
Looks like there's a smaller one in the bunch?
-
Sidekick reacted to Rdrcr's post in the thread L2501 Turbo: A Journey Defined - The tractor, The comparison, The modification, The results... with Like.
Turbo day!!! Only two boxes left to go! We are working diligently getting production back up to speed here at the shop. We know there...
-
Sidekick reacted to Yooper's post in the thread Got some advice for a “3 way” ……….(from my wife…;)…..(she thinks it’s better in the front, not the rear?) with Like.
If my mill dro dies I will have a new one on order that same day! Can’t imagine using the mill without one!
-
Sidekick reacted to torch's post in the thread Got some advice for a “3 way” ……….(from my wife…;)…..(she thinks it’s better in the front, not the rear?) with Like.
Woodruff keys are an alignment tool. They are supposed to be softer than the parts they are aligning.
-
Sidekick reacted to Yooper's post in the thread Got some advice for a “3 way” ……….(from my wife…;)…..(she thinks it’s better in the front, not the rear?) with Like.
I put feeds on all three axis on my mill. Probably can count the number of times I have used the Y axis feed on one hand. Don’t get me...
-
Sidekick reacted to KubotaHawg's post in the thread What did you do to or on your Kubota today? with Like.
Should have taken a before but this is after grading and packing with truck From bottom From top It’s steep—heavier tractor would help...
-
The nice part is that living in AZ, you can probably just leave it out in the elements? Up here, the snow/rain/weeds/salt would...
-
Sidekick replied to the thread Vacuum sealing pew pew seeds.I do not vacuum seal them. High vacuum can dislodge the bullets in the loaded ones and be a problem later. Vacuum can cause moisture...
-
The only "obvious" explanation is that the air in the cartridge case eventually gets past the bullet and/or primer given some time, i.e...
-
Sidekick reacted to S-G-R's post in the thread What did you do to or on your Kubota today? with Like.
Ready to give the driveway a scrape. I did it a couple of weeks ago and we got a lot of rain in the past few days. Got the front PHD on...