MtnViewRanch's latest activity
-
MtnViewRanch replied to the thread Rear remotes.I'm curious, how and where are you thinking of mounting the valves and couplers? :unsure: -
MtnViewRanch replied to the thread 3 point hitch adjustments.The 18 1/8-26 3/8" will work fine for you. I typically recommend an 18"-26" working length.
-
MtnViewRanch replied to the thread 3 point hitch adjustments.Look at the following link to determine the best overall hydraulic link working range. https://fitritehydraulics.com/toplink.html Not...
-
MtnViewRanch replied to the thread New L47 Rear Remote Valve.If you are talking about having 2 hydraulic side links and having them long enough that the lift arms lift as far as they can and then...
-
MtnViewRanch replied to the thread New L47 Rear Remote Valve.Top & tilt set if you do much grading. Similar to those pictured. Lots of different implements that can make use of them. Rear grading...
-
-
MtnViewRanch replied to the thread Rebuilding hydraulic cylinder and miss placed/ mixed a part..Yes, the piston with the pressure relief goes in the ripper actuating cylinder.
-
MtnViewRanch replied to the thread B3030 Top and Tilt Hydraulics - 3 Point Rear Remotes.You won't. The Kubota cylinder (if you can even purchase the side link alone) has #6 o-ring boss ports. No one other than Fit Rite that...
-
-
MtnViewRanch replied to the thread B3030 Top and Tilt Hydraulics - 3 Point Rear Remotes.Look at the picture. If I remember correctly, the top clevis is at 16* with a 5/8" pin hole and the lower clevis is at 7* and has a...
-
-
MtnViewRanch replied to the thread B3030 Top and Tilt Hydraulics - 3 Point Rear Remotes.The 18 1/8" - 26 3/8 top link would be fine, just need to grind the tractor end ball swivel down to 1 9/16" wide. I don't think that...
-
MtnViewRanch replied to the thread M6060 Rear Remote disconnects.If you have a plug-in multiplier, that in itself can be the issue. That is a lot of weight hanging off of the couplers.
-
MtnViewRanch replied to the thread B7200D Top Link.Actually I believe that it is 1 9/16" wide. Other than an OEM top link, you will most likely need to grind one down from 1 3/4" wide...
-
MtnViewRanch reacted to North Idaho Wolfman's post in the thread M62? M59? Or something else with
Like.
Can you work on or maintain a tractor yourself? If not, don't go used. TLB's are great but they have their downfalls. A TLB is not very... -
MtnViewRanch replied to the thread Pat's Quick Hitch compatibility with Gearmore's Tip and Tilt kit for BB1260 box blade.To the best of my knowledge, the pin-pin length added on every Pat's QH cat 1 or cat 2 is 3 3/4".
-
MtnViewRanch replied to the thread Pat's Quick Hitch compatibility with Gearmore's Tip and Tilt kit for BB1260 box blade.Pat's QH adds 3 3/4" to the draft arm length. A good working length for you would be 23"-35".
-
MtnViewRanch replied to the thread Summit Hydraulics multipliers and Scorpion Technologies control grips.You guys are correct, adding the diodes extends switch life, no question. My point is that it is not needed under typical homeowner use...
