Kennyd4110's latest activity
-
Kennyd4110 reacted to S-G-R's post in the thread Fit-Rite hydraulic top link installed today with
Like.
Brian makes nice parts. I just got my T&T kit on this afternoon. I missed not having a hydraulic top link since I sold my LX3310. -
Kennyd4110 reacted to S-G-R's post in the thread What did you do to or on your Kubota today? with Like.
Got my Fit Rite Hydraulics top and side link installed. Excellent fit and finish and I can't wait to try them out with the land plane...
-
I'm not brave enough to power tap that grade of steel.
-
Why Pats? A standard quick hitch would be even easier.
-
I don't think it's going to be that big of a problem. Switching tires/wheels is pretty expensive. Have you thought about chaining up...
-
Kennyd4110 replied to the thread R4 to ag tires.And wheels. R1's are much narrower and will not usually mount on the same rims that R4's do.
-
Kennyd4110 replied to the thread Single Acting Hydraulics.Are you operating the control "the other way" to get it to fall? The pump will go into relief (engine lugging some) while its held...
-
Kennyd4110 replied to the thread It's been sorta quite around OTT recently."Quite" or "Quiet" :ROFLMAO:
-
Kennyd4110 reacted to Runs With Scissors's post in the thread Too fat/lazy/old to unlock your SSQA?????……..Then follow me ;) with Like.
Now I have to cut that slot. It is at this time, I “remember” that I have do not have a good method of holding a tube whilst trying to...
-
Kennyd4110 reacted to #40Fan's post in the thread Fit-Rite hydraulic top link installed today with Like.
Loosen this fitting, then grab the hose and twist so it follows closer to the other one, then tighten fitting....is what he is trying to...
-
Kennyd4110 replied to the thread Fit-Rite hydraulic top link installed today.Yes, exaclty what @#40Fan wrote.
-
Kennyd4110 replied to the thread Fit-Rite hydraulic top link installed today.Nice, great quality stuff! Note: you should be able to loosen that lower hose at the JIC fitting and 'clock' it better so it follow the...
-
Kennyd4110 reacted to racerboy's post in the thread Fit-Rite hydraulic top link installed today with Like.
I got my L6060 back from the dealer today. It was there because I traded in my BH92 for a KX-033 mini-excavator, and that was the...
-
These are cuts from my Hypertherm 45. Just under 3/8 steel that is near the high limit on duty cycle when cutting a sheet full. Will do...
-
220V, 50A circuit my supply gas: 78% nitrogen, 21% oxygen and 1% other misc gasses