Recent content by Jesús

I'm not entirely sure how to change these seals or how many they have... the truth is that I'm new to this world of Mini Tractors and I don't have much of an idea.

Hello, after checking more parts of my Kubota B6000, I found there was no oil in the front, rear, or center assembly. I'm attaching photos in case you can help me find the part numbers without disassembling it so it can be moved if the parts take a long time. Thanks, best regards.

This is

Hello, the rotavator on my original Kubota B6000 has broken. The bearings on the blade shaft split, and the tractor suddenly stopped, stuck. Has anyone repaired this accessory? Is it very difficult to remove the bearings and replace them with new ones? If anyone has the part number for these and...

https://www.tracpartz.es/adaptadores-por-enganche-tripuntal-kubota-b6000.html https://www.tracpartz.es/kubota-soporte-tercer-punto-b-serie.html Hello, I bought a cultivator and now I need, in addition to the three-point kit for my Kubota B6000, some adapters for the tractor. According to the...

I cleaned the diodes and the case, cleaned the wires, and soldered them together to ensure a good connection. It finally seems to work, thanks…

New news!

By the way, how do I remove the rust from the box without damaging it?

Thank you very much for your help, it seems that the light switch has a lot to do with the battery charging process, I have two loose cables, one white and one blue, let's see where each one goes... the diagram is not completely clear to me but it does help me understand how it works, if you...

Could it be this box? I'd like to know how to check if it's in good condition, and if not, throw in the towel and take it to a specialized electrical workshop. The cables don't look very good, some are loose, I've relocated them, but I'm not sure exactly where I should have put them. Connections...

Can someone tell me where the regulator is located on my Kubota B6000?

Hello again, friends. I just reinstalled the dynamo on my Kubota, and at idle, it's 11.4 volts (low idle, not at all accelerated). Where could the problem be? Based on this, I only want to know if the current output is good. Therefore, I should look for a faulty regulator or some other component.

Hi, I checked it again with the lathe at 1470 rpm and it gives 7.1 volts, therefore at 2500 rpm it offers 12v according to my calculations.

I did it with a lathe to check, maybe it had low rpm?