Recent content by Fluke216

OkI see makes sense thanks for that explanation and all the responses. I don’t know why I didn’t think about it I guess the machine was completely dead when I took the backhoe off and didn’t think about plugging them together

I tried to get it but he wanted to keep it on the loader for some reason. I could have him measure it and probably make something out of threaded rod and some modified pieces on the ends.

Thank for that detailed response I was still a little confused as some conversation between you guys about what created the actual dead head. I created it by not plugging the lines together that were removed from the backhoe. The method of how it happened was one way or the other but is evident...

Hmmm I think they were definitely switched and the ones to the backhoe were not plugged together. Does that create the dead head? I hooked the new one up double check led it was all hooked up correctly seems to function fine boom goes up and bucket dumps and curls. Only check that quick then...

Does this make more sense if the tank and power beyond lines were reversed. Because I’m thinking that’s probably what happened the line from to the tank is clear.

I went and got the Valve, the whole setup. Left before 2 got back after 10. I also got the pressure relief valve that was on that machine it looks better than mine. Should I have it tested or test it following the wsm. Thanks for all the information here much appreciated just wanted to clarify...

Ok I’ll reply more back to this I’m headed on the road now. Thank you

Ok Thank you for that Explanation much appreciated. yes the Bucket Section is the one that blew up as i guess makes sense its the function that wasn't working it would dump but not roll back the boom was going up and down fine. The bucket section is not much of a concern because you are only...

I’m slightly confused. Also I think I said the wrong thing looks like the back valve is the bucket control. Trying to understand, as you mean if not replaced oem there will be no float function or something else please dumb it down if you need to or maybe I was missing what you meant sorry and...

Ok sorry just to clarify I didn’t see any relief valve on the loader valve at all. Just this on the transmission which I think I was wrong, I think it is the relief valve that I’m assuming was rusted shut and not functioning ? Is there a way to clean this up or should I replace it. Thanks...

Ok I’ll see what pans out here depending that might be my option. Thanks

Ok right I’m going to try and go get it. Here’s where it shows the relief valve on top of the transmission. I took the seat off and cover and it’s just a bolt in there so I guess maybe there’s another one at a different location ?

I blew up the back one so the boom one.